steering power cylinder Sold to Switzerland

This article mainly introduces:

Switzerland hydraulic cylinder,steering power cylinder manufacturer,steering power cylinder

(Switzerland steering power cylinder,produced by Hengyu Hydraulic Co., Ltd）

steering power cylinder are widely used in Switzerland，because of high work efficiency，excellent fatigue and impact resistance，no need for deceleration device.So our company has designed steering power cylinder for customers from Switzerland.

Introduction to steering power cylinder:

Under normal circumstances, the steering power cylinder is composed of the rear end cover, body, piston, piston rod and front end cover and other main parts. In order to prevent the working medium from leaking out of the steering power cylinder or from the high pressure chamber to the low pressure chamber, a sealing device (sealing ring) is arranged between the steering power cylinder and the end cover, the piston and the piston rod, the piston and the steering power cylinder, the piston rod and the front end cover. A dustproof device is also provided on the outside of the front end cover. In order to prevent the piston from impacting the end cap when it moves rapidly to the end of the stroke, the end of the steering power cylinder can also be provided with a buffer device. If necessary, the exhaust device should be set in order to exhaust.

After chrome plating of the piston rod of the steering power cylinder, the surface flatness is not fully treated: After chrome plating of the piston rod surface, the method of post-plating polishing should be changed to post-plating polishing. Although it is necessary to increase the thickness of the coating before grinding (generally increased by about 0.02 in the diameter direction), it can remove chrome plating defects well, and test the binding force of the coating. In addition, due to the micro-roughness of the grinding surface, the trough can store lubricating oil, which can improve the wear resistance and extend the service life.

After the steering power cylinder is installed, lubricating grease should be added to the relative moving parts such as earring and middle hinge shaft before trial operation.

If the piston rod and steering power cylinder are stuck or the steering power cylinder is blocked, at this time, no matter how to operate, the steering power cylinder does not move or has little action. At this time, check whether the piston and piston rod seal is too tight, whether it enters the dirt and gum deposits: whether the shaft line of the piston rod and the steering power cylinder is in the center, whether the wearing parts and seals are invalid, and whether the load is too large.

Answers to some questions about steering power cylinder:

What material should be selected to seal the cylinder?
The choice of material for sealing is related to the working environment, strength, and medium of your equipment.

What valve is used to control the speed of the cylinder?
Hydraulic cylinder for lifting is generally the piston rod downward installation, to achieve the fast and slow speed of the cylinder, you can add a two-digit three-way electromagnetic reversing valve + a throttle valve on a branch at the bottom of the cylinder, you can achieve speed change, control mode can be controlled by time control can also be controlled by stroke switch. If you want to achieve more accurate control can use proportional valve control.