push and pull the cylinder Sold to Panama

This article mainly introduces:

Panama hydraulic cylinder,push and pull the cylinder manufacturer,push and pull the cylinder

(Panama push and pull the cylinder,produced by Hengyu Hydraulic Co., Ltd）

push and pull the cylinder are widely used in Panama，because of powerful torque，excellent temperature resistance，no transmission clearance.So our company has designed push and pull the cylinder for customers from Panama.

Introduction to push and pull the cylinder:

push and pull the cylinder hydraulic oil selection: The recommended working oil viscosity of the push and pull the cylinder is 10 ~ 110cSt (1.8 ~ 15E), ISO VG46 hydraulic oil. The normal working oil temperature is 10 ~ 70℃, and the ambient temperature is in the range of -20 ~ 80℃. When the ambient temperature and service temperature are low, the hydraulic oil with lower viscosity can be selected.

Piston push and pull the cylinder is widely used in hydraulic transmission. When the push and pull the cylinder works, it mainly delivers hydraulic oil alternately to both sides of the piston in the push and pull the cylinder, and uses the pressure difference of hydraulic oil on both sides of the piston to realize the reciprocating movement of the piston. If you want to speed up the forward speed of the piston, the return oil in the push and pull the cylinder can be controlled by the valve and directly input into the inlet pipe to participate in the work of the piston to achieve rapid movement of the piston, but the thrust of the piston is reduced much.

The pressure of the sliding surface of the push and pull the cylinder piston is too large, resulting in sintering. The piston tilts due to the weight of the piston rod, resulting in the phenomenon of non-stiffness, or the pressure of the sliding surface of the piston rises due to the action of the transverse load, which will cause sintering. In the design of the push and pull the cylinder must study its working conditions, the length of the piston and bushing and the size of the clearance must be fully paid attention to.

In the process of using the push and pull the cylinder, sometimes such a problem will occur, the push and pull the cylinder can not act immediately after the instruction of the push and pull the cylinder action is issued, and it must be moved after a short time, or sometimes it can move and stop moving, showing that the operation is very irregular. The cause and elimination of this failure mainly include air in the oil push and pull the cylinder. Elimination method: exhaust through the exhaust valve. Check the piston rod reciprocating parts of the sealing ring for air inhalation, if so, replace the sealing ring.

Answers to some questions about push and pull the cylinder:

How does the hydraulic solenoid valve realize that the cylinder stops at any position?
Use an O-type medium function solenoid directional valve, or use a Y-type solenoid directional valve and a hydraulically controlled check valve.

Where is the cylinder used? What is it used for? Can it be used in cars?
Cylinders can be used as actuator in hydraulic system. Such as hydraulic jacks, dump truck box lifting device, dodging (snow) machine loader bucket lifting device. Hydraulic cylinders are also widely used in car cranes. It's all about cars.