forklift hydraulic cylinder Sold to Denmark

This article mainly introduces:

Denmark hydraulic cylinder,forklift hydraulic cylinder manufacturer,forklift hydraulic cylinder

(Denmark forklift hydraulic cylinder,produced by Hengyu Hydraulic Cylinder Factory）

forklift hydraulic cylinder are widely used in Denmark，because of long service life，smooth movement，high work efficiency.So our company has designed forklift hydraulic cylinder for customers from Denmark.

Introduction to forklift hydraulic cylinder:

When installing the forklift hydraulic cylinder, the axial ends of the forklift hydraulic cylinder cannot be fixed. Due to the effect of liquid pressure and thermal expansion in the forklift hydraulic cylinder, there is axial expansion. If the two ends of the forklift hydraulic cylinder are fixed, all parts of the forklift hydraulic cylinder will be deformed. When disassembling the forklift hydraulic cylinder, it is strictly forbidden to hammer the forklift hydraulic cylinder and the piston surface, such as the forklift hydraulic cylinder hole and the piston surface is damaged, do not allow sandpaper grinding, to use a fine oil stone carefully grinding. The clearance between the guide sleeve and the piston rod should meet the requirements.

forklift hydraulic cylinder buffer valve inspection and maintenance: For the valve buffer forklift hydraulic cylinder, the focus should be on checking the wear of the buffer valve spool and seat. Once it is found that the amount of wear increases and the seal fails, it should be replaced. It can also be repaired by using abrasive spool and seat matching grinding method.

The forklift hydraulic cylinder should not be mixed with foreign objects during assembly, which will cause scars. Before the total assembly of the forklift hydraulic cylinder, all parts must be fully removed and cleaned. When the parts are installed with burrs or dirt, foreign objects are easily embedded into the surface of the forklift hydraulic cylinder wall due to the stiffness and the weight of the parts, causing scars.

At the rated pressure, the thrust of the forklift hydraulic cylinder is determined by what factors: at the rated pressure of the oil pump, the work done by the forklift hydraulic cylinder is related to the diameter of the forklift hydraulic cylinder, but not to the stroke of the forklift hydraulic cylinder. Moreover, the larger the forklift hydraulic cylinder diameter, the larger the area, and the greater the pressure obtained. To this point, we should have a correct understanding and clear understanding, so as to avoid problems in the use of the forklift hydraulic cylinder.

Answers to some questions about forklift hydraulic cylinder:

Where is the cylinder used? What is it used for? Can it be used in cars?
Cylinders can be used as actuator in hydraulic system. Such as hydraulic jacks, dump truck box lifting device, dodging (snow) machine loader bucket lifting device. Hydraulic cylinders are also widely used in car cranes. It's all about cars.

What is the bearing capacity of the HOB cylinder?
The normal specification of HOB is 140 kg pressure, which is more commonly used in the market, and there are clear marks on the cylinder, 210 kg is a strengthened version of HOB, generally customized cylinders are also clearly marked on the above, when the specific use of the cylinder, the maximum use pressure is marked on the cylinder.