tailplate hydraulic cylinder Sold to Spain

This article mainly introduces:

Spain hydraulic cylinder,tailplate hydraulic cylinder manufacturer,tailplate hydraulic cylinder

(Spain tailplate hydraulic cylinder,produced by Hengyu Hydraulic Co., Ltd）

tailplate hydraulic cylinder are widely used in Spain，because of high work efficiency，excellent fatigue and impact resistance，no need for deceleration device.So our company has designed tailplate hydraulic cylinder for customers from Spain.

Introduction to tailplate hydraulic cylinder:

In the hydraulic system, sometimes the inner layer of the rubber hose is peeled off, so that the oil circuit is on and off, resulting in irregular tailplate hydraulic cylinder action. Troubleshooting method: Replace the rubber hose.

The commonly used buffer structure of the tailplate hydraulic cylinder is composed of a piston boss and a tailplate hydraulic cylinder head groove. When the piston moves close to the tailplate hydraulic cylinder head, it gradually enters the groove, and the oil in the groove is extruded through the gap between the boss and the groove, which increases the oil return resistance, produces the braking effect and realizes the buffer. Generally, a buffer mechanism should be used when the pressure is above 10MP.

The tailplate hydraulic cylinder should be used as far as possible to avoid the transverse force, sometimes the piston rod to bear the transverse load is too large, especially do not force or pull the tailplate hydraulic cylinder, bite. Elimination method: When installing the tailplate hydraulic cylinder, ensure that the axis position of the tailplate hydraulic cylinder is consistent with the direction of movement; Make the load borne by the tailplate hydraulic cylinder as far as possible through the tailplate hydraulic cylinder axis, to avoid the phenomenon of eccentricity.

When the tailplate hydraulic cylinder is in use, ensure that the tailplate hydraulic cylinder and the surrounding environment should be clean. The tank should be sealed to prevent contamination. Pipelines and fuel tanks should be cleaned to prevent falling off the oxide sheet and other debris. Clean with lint-free cloth or special paper. Twine and binder should not be used as sealing materials. Hydraulic oil according to the design requirements, pay attention to the change of oil temperature and oil pressure. When there is no load, unscrew the exhaust bolt for exhaust.

Answers to some questions about tailplate hydraulic cylinder:

What are the main dimensions of the cylinder?
The main dimensions of the cylinder include: cylinder inner diameter, piston cylinder diameter, cylinder length, cylinder wall thickness, stroke, installation distance, etc.

To achieve the same stroke, which is better, hydraulic cylinder or lead screw?
If there is batch action, then the hydraulic pressure is better. Hydraulic: smooth operation, no lubrication, easy control, high control accuracy (can use proportional or servo system), the key is to manually control, but certainly to support the hydraulic system, for a single action must cost. Maintenance costs are also high. Lead screw: simple structure, easy to achieve, convenient maintenance, but must be lubricated, can not be manual, or manual control is inconvenient. See where it is used, if it is used in high-precision occasions, it must only be hydraulic, because the lead screw has a gap. There are many hydraulic actions, the hydraulic system itself must be prepared, then the use of hydraulic pressure is also very economical.