steering power cylinder Sold to Libya

This article mainly introduces:

Libya hydraulic cylinder,steering power cylinder manufacturer,steering power cylinder

(Libya steering power cylinder,produced by Hengyu Group）

steering power cylinder are widely used in Libya，because of clever hydraulic energy conversion，excellent temperature resistance，simple structure and reliable operation.So our company has designed steering power cylinder for customers from Libya.

Introduction to steering power cylinder:

When the steering power cylinder is in use, once the seal and guide support ring are found to be defective, the seal with the same structural form and appropriate material should be replaced according to the structural form of the steering power cylinder seal to be repaired, so as to minimize the thickness of the oil film between the seal and the sealing surface and reduce the leakage of the seal.

In order to ensure the service life of the steering power cylinder, the hydraulic system must be set up effective filtration to prevent pollution, the cleanliness of the oil should meet the ISO4406 standard, and the quality of the filtration should also meet the corresponding standards in ISO. The grade requirements of the filter are performed according to the actual working conditions of the system, but the minimum requirements are not less than 19/15 in ISO4406, that is, 24μ (β10≥75) in ISO4572.

steering power cylinder is the most important part of construction machinery, the traditional processing method is: broaching steering power cylinder block - fine boring steering power cylinder block - grinding steering power cylinder block. The rolling method is: broaching steering power cylinder block - fine boring steering power cylinder block - rolling steering power cylinder block, the process is 3 parts, but the time is compared: grinding 1 meter of the steering power cylinder block is about 1-2 days, rolling 1 meter of the steering power cylinder block is about 10-30 minutes. Input comparison: grinding machine or quilting machine (tens of thousands - millions), rolling knife (ten thousand - tens of thousands). After rolling, the surface roughness of the hole decreases from RA3.2-6.3 μm before rolling to Ra0.4 ~ 0.8μm, the surface hardness of the hole increases by about 30%, and the fatigue strength of the inner surface of the steering power cylinder increases by 25%. If the steering power cylinder life is only considered, it is increased by 2 to 3 times, and the boring and rolling process is 3 times more efficient than the grinding process In particular, if you want to make high-quality steering power cylinders, you must take the rolling production process. After the steering power cylinder is rolled, there is no sharp tiny edge on the surface, and long-term motion friction will not damage the seal ring or seal, which is particularly important in the hydraulic industry.

The meaning of the steering power cylinder model marked by the steering power cylinder manufacturer: for example, 160/100-1150, its meaning: from a professional point of view, 160 refers to the steering power cylinder diameter, which is 160mm, and the 100 behind refers to the rod diameter, which is 100mm. The 1150 refers to the steering power cylinder stroke, which is 1150mm. Therefore, on this point, we should have a correct understanding and can not make mistakes.

Answers to some questions about steering power cylinder:

What is the smallest cylinder size?
The smallest shape cylinder I have ever seen is a hydraulic clamping cylinder in the machine tool industry. Outer diameter 24 mm, total length 23 mm, travel 4 mm. Weighs 0.05 kg. Maximum clamping force 3500 Newtons.

What is a hydraulic cylinder assembly?
Assembly, which means aggregate. A series of parts or products, formed to achieve a specific function of the whole, the general term for this system is assembly. The hydraulic cylinder assembly is not a single hydraulic cylinder part, which can be used by connecting the hydraulic hose.