stainless steel cylinder Sold to Kenya

This article mainly introduces:

Kenya hydraulic cylinder,stainless steel cylinder manufacturer,stainless steel cylinder

(Kenya stainless steel cylinder,produced by Hebei Hengyu company）

stainless steel cylinder are widely used in Kenya，because of high work efficiency，long service life，smooth movement.So our company has designed stainless steel cylinder for customers from Kenya.

Introduction to stainless steel cylinder:

How to determine the working pressure of the stainless steel cylinder: The pressure depends on the load size (i.e., F) and the type of equipment. The limitations of assembly space, economic conditions and component availability of the actuator should also be considered. In the case of a certain load, it is necessary to increase the structural size of the actuator if the working pressure is low, for some equipment, the size may be limited, and it is not economical from the point of view of material consumption; On the contrary, if the pressure selection is too high, the material, sealing and manufacturing accuracy of the pump, stainless steel cylinder, valve and other components are also required to be high, which will inevitably increase the cost of equipment. In general, for equipment with a fixed size that is not too limited, the pressure can be selected lower, and the walking machinery should be selected higher.

Protection of the stainless steel cylinder surface: During the dismantling process, safety protection should be carried out on the stainless steel cylinder to prevent objects from falling and welding slag from falling to the surface, causing damage to the stainless steel cylinder surface. In the process of propulsion, the damaged pipe segments should be prevented from falling and smashing, and the slurry remaining on the surface of the stainless steel cylinder should be cleaned up in time.

Because of the slightly complex structure of the buffer stainless steel cylinder, sometimes there will be problems, such as when the stainless steel cylinder with the buffer device is started in reverse, the piston often stops temporarily or reverses. Elimination method: The orifice of the check valve is too small, so that the amount of oil entering the buffer chamber is too small, and even a vacuum occurs, so the above fault phenomenon will occur when the buffer plunger leaves the end cover. In this regard, the orifice of the check valve should be increased.

stainless steel cylinder seal leakage causes and countermeasures: a. Loose tie rod nut will cause leakage, tighten the tie rod nut according to the torque requirements of tie rod nut, test no leakage can continue to use. b. Pressure exceeding the limit will also cause leakage. Replace the stainless steel cylinder seal and re-tighten the tie rod nut to reduce the pressure to the nominal pressure range of the stainless steel cylinder. c. The stainless steel cylinder seal is extruded, if the O-ring is obviously extruded at the stainless steel cylinder seal, replace the stainless steel cylinder seal.

Answers to some questions about stainless steel cylinder:

Cylinder pressure calculation formula
The pressure of the cylinder at work is determined by the load, and the pressure of the physical force is equal to the force divided by the area of action (that is, P=F/S). If you want to calculate the output force of the cylinder, you can calculate it according to the formula: Set the radius of the piston (that is, the cylinder) is R (unit mm) the radius of the piston rod is r (unit mm) the working pressure P (unit MPa) the thrust of the cylinder F push =3.14*R*R*P (unit N) The pulling force of the cylinder F pull =3.14* (R*R-r* R) *P (unit N).

Why is a light cylinder less productive than a heavy cylinder at the same oil pressure?
f=ps Under the same pressure, the larger the area, the greater the output, but the maximum pressure can not exceed the system engineering pressure of the cylinder!