booster cylinder Sold to Australia

This article mainly introduces:

Australia hydraulic cylinder,booster cylinder manufacturer,booster cylinder

(Australia booster cylinder,produced by Hengyu Hydraulic Cylinder Factory）

booster cylinder are widely used in Australia，because of high work efficiency，excellent fatigue and impact resistance，no need for deceleration device.So our company has designed booster cylinder for customers from Australia.

Introduction to booster cylinder:

When producing oil booster cylinders, there are two processing processes, grinding and rolling, the latter is better than the former. Rolling machining is a kind of non-cutting machining, using the plastic deformation of the metal at room temperature, so that the micro roughness of the workpiece surface is flattened to achieve the purpose of changing the surface structure, mechanical characteristics, shape and size. Therefore, this method can achieve the two purposes of finishing and strengthening at the same time, which can not be done by grinding.

The booster cylinder should be used as far as possible to avoid the transverse force, sometimes the piston rod to bear the transverse load is too large, especially do not force or pull the booster cylinder, bite. Elimination method: When installing the booster cylinder, ensure that the axis position of the booster cylinder is consistent with the direction of movement; Make the load borne by the booster cylinder as far as possible through the booster cylinder axis, to avoid the phenomenon of eccentricity.

When the oil pressure of the booster cylinder inlet is too low to reach the specified value, the leakage situation of the relevant oil system should be checked and the leakage should be eliminated; Check the piston and piston rod seal ring for damage, aging, loose and other phenomena; Check whether the hydraulic pump and pressure valve are faulty.

The "O" ring can be used as an auxiliary seal inside the booster cylinder, and the elastic force of the "O" ring makes the sealing slip ring close to the sealing surface, generating sealing pressure to achieve sealing. When the internal hydraulic pressure increases, the "O" ring will further deform and squeeze the slip ring, thereby increasing the sealing pressure and improving the sealing performance. The structure has the characteristics of low friction coefficient, good wear resistance, automatic compensation for wear and absorption of hard particles in the booster cylinder, and can be completely sealed.

Answers to some questions about booster cylinder:

What are the main dimensions of the cylinder?
The main dimensions of the cylinder include: cylinder inner diameter, piston cylinder diameter, cylinder length, cylinder wall thickness, stroke, installation distance, etc.

Is a hydraulic cylinder and a jack the same thing?
Strictly speaking, no. Although the hydraulic principle is used, and even some of the longer jacks are similar to the cylinder, the internal structure of the two is different. There is a check valve inside the jack. After the top lift, the check valve locks the hydraulic oil circuit, and the hydraulic oil only enters and does not exit after the check valve locks, and can be lowered to complete a reciprocating movement. The cylinder is usually connected to the distribution tube to control the movement, and works with a wide variety of distribution valves and distribution systems according to different needs. The jack only needs a simple check valve.