HSG engineering cylinder Sold to Malaysia

This article mainly introduces:

Malaysia hydraulic cylinder,HSG engineering cylinder manufacturer,HSG engineering cylinder

(Malaysia HSG engineering cylinder,produced by Hengyu Group）

HSG engineering cylinder are widely used in Malaysia，because of excellent temperature resistance，no transmission clearance，powerful torque.So our company has designed HSG engineering cylinder for customers from Malaysia.

Introduction to HSG engineering cylinder:

At the rated pressure, the thrust of the HSG engineering cylinder is determined by what factors: at the rated pressure of the oil pump, the work done by the HSG engineering cylinder is related to the diameter of the HSG engineering cylinder, but not to the stroke of the HSG engineering cylinder. Moreover, the larger the HSG engineering cylinder diameter, the larger the area, and the greater the pressure obtained. To this point, we should have a correct understanding and clear understanding, so as to avoid problems in the use of the HSG engineering cylinder.

The wear of the hard chromium plating layer of the HSG engineering cylinder is mostly caused by the grinding of the friction iron powder of the piston, and the wear is faster when there is water in the middle. Corrosion caused by the contact potential difference of the metal only occurs in the part of the piston contact, and the corrosion occurs in a point pattern. As mentioned above, when there is moisture in the middle, it will promote the development of corrosion. Compared with castings, the contact potential difference of copper alloy is higher, so the corrosion degree of copper alloy is more serious.

When the HSG engineering cylinder wear is serious, you can try to use an alloy scraper to shave grooves with a depth of more than 1mm on the surface of the slip injury, then clean the grooves with acetone, apply the adjusted TS311 anti-wear repair agent on the polished surface with the HSG engineering cylinder inner diameter copying plate, and scrape it flat vigorously to ensure compaction and higher than the inner surface of the HSG engineering cylinder. After curing, polish to leave a finishing margin. Finally, the overall size, shape tolerance and roughness of the HSG engineering cylinder can meet the requirements by grinding. However, the life and reliability of this repair HSG engineering cylinder are not high.

The HSG engineering cylinder can not be used as grounding electrode to avoid electric damage to the piston rod.

Answers to some questions about HSG engineering cylinder:

Classification and application of cylinders.
Hydraulic cylinder is divided into single acting hydraulic cylinder, double acting cylinder, combined hydraulic cylinder, swing hydraulic cylinder. Single acting cylinder is divided into plunger type hydraulic cylinder, single piston rod hydraulic cylinder, double piston rod hydraulic cylinder, telescopic hydraulic cylinder. Plunger type hydraulic cylinder: the plunger moves only in one direction, and the return stroke is to push the plunger back using its own weight or load. Single piston rod hydraulic cylinder: The piston moves only in one direction, and the return stroke is to push the plunger back using dead weight or load. Double piston rod hydraulic cylinder: both sides of the piston are equipped with piston rods, and pressure oil can only be supplied to one side of the piston. The return stroke usually uses spring force, gravity or external force. Telescopic hydraulic cylinder: It obtains long stroke with short cylinder. The hydraulic oil is pushed out from large to small section by section, and the external force is reduced from small to large.

How does the one-way solenoid valve control the hydraulic cylinder circuit?
If your cylinder is single-acting, you can use a one-way solenoid valve, such as some lifting platform hydraulic cylinder, the support valve used is one-way (two-position tee), that is, the cylinder extends out by the oil pressure top, the cylinder retracted by its own weight.