series synchronous cylinder Sold to Italy

This article mainly introduces:

Italy hydraulic cylinder,series synchronous cylinder manufacturer,series synchronous cylinder

(Italy series synchronous cylinder,produced by Hengyu Hydraulic Cylinder Factory）

series synchronous cylinder are widely used in Italy，because of excellent fatigue and impact resistance，smooth movement，high work efficiency.So our company has designed series synchronous cylinder for customers from Italy.

Introduction to series synchronous cylinder:

The series synchronous cylinder is not the same as the series synchronous cylinder, because the pressure of the pneumatic system is generally within the range of 0.2-1.0Mpa, the series synchronous cylinder can not be used as a high-power power component, but the series synchronous cylinder can be used as a relatively large power component, or the series synchronous cylinder system can be used.

The series synchronous cylinder should not be mixed with foreign objects during assembly, which will cause scars. Before the total assembly of the series synchronous cylinder, all parts must be fully removed and cleaned. When the parts are installed with burrs or dirt, foreign objects are easily embedded into the surface of the series synchronous cylinder wall due to the stiffness and the weight of the parts, causing scars.

We can not just consider the price and ignore the quality when we purchase the series synchronous cylinders. Now some manufacturers produce unqualified products in order to reduce costs, the piston rod is not adjusted, the rod coating is not enough, the series synchronous cylinder finish can not reach, the guide sleeve should use copper, but instead of ductile iron, although the cost is reduced, the quality of the series synchronous cylinder is not required.

When installing the series synchronous cylinder pipe, the pipe should be cleaned after installation, and should not pass through the series synchronous cylinder block, and the by-pass pipe must be installed in front of the oil port of the series synchronous cylinder block. This is important. Otherwise, the foreign body in the pipeline will enter the series synchronous cylinder, and once it enters, it is difficult to exclude it, but it becomes a foreign body transported to the series synchronous cylinder. Moreover, when cleaning, the removal method of foreign bodies entered in the installation pipeline operation should be considered. In addition, the corrosion in the pipe should be pickling and other procedures before the pipe installation, and the rust must be completely removed.

Answers to some questions about series synchronous cylinder:

When the superimposed hydraulic control valve is added to the bottom of a solenoid valve and a double directional throttle valve, why does the cylinder shock on the return trip?
The stack hydraulic control check valve must be added above the stack one-way throttle valve.

What is the relationship between medium cylinder and side cylinder ratio of forklift truck?
The middle cylinder and the side cylinder seem to have no relationship, as long as the lifting speed required by the design can be ensured, but the diameter of the cylinder can not be too thin, so as to avoid the middle cylinder acting first when the high gantry vibration lifting, and then the two cylinders acting again.