baling press cylinder Sold to Japan

This article mainly introduces:

Japan hydraulic cylinder,baling press cylinder manufacturer,baling press cylinder

(Japan baling press cylinder,produced by Hengyu Hydraulic Cylinder Factory）

baling press cylinder are widely used in Japan，because of excellent temperature resistance，smooth movement，high work efficiency.So our company has designed baling press cylinder for customers from Japan.

Introduction to baling press cylinder:

The repair method of the baling press cylinder: the repair of the baling press cylinder must use brush plating. This is because this repair method can be carried out on site, and the repair effect is good. In this way, loading and transportation can be eliminated to shorten the repair time and improve work efficiency. In addition, the coating obtained by brush plating has good binding force and will not have obvious boundaries. Moreover, the repair surface has high hardness and good wear resistance.

When installing the baling press cylinder, the axial ends of the baling press cylinder cannot be fixed. Due to the effect of liquid pressure and thermal expansion in the baling press cylinder, there is axial expansion. If the two ends of the baling press cylinder are fixed, all parts of the baling press cylinder will be deformed. When disassembling the baling press cylinder, it is strictly forbidden to hammer the baling press cylinder and the piston surface, such as the baling press cylinder hole and the piston surface is damaged, do not allow sandpaper grinding, to use a fine oil stone carefully grinding. The clearance between the guide sleeve and the piston rod should meet the requirements.

The baling press cylinder should be avoided for a long time without use, if it is indeed idle for a long time for some reason, it should also be regularly turned on for empty operation, so that its parts can be fully lubricated, so as to avoid rust on the working surface and affect the normal work in the future. (If it cannot be turned on and run, a small amount of lubricating oil can be applied on its outer surface for protection) ' The use of the baling press cylinder should pay attention to: the operation should be as far away from the baling press cylinder as possible, to avoid falling objects, knocking, rubbing the baling press cylinder coating. When cleaning the baling press cylinder, only use soft materials (such as cotton) to wipe, and do not scratch high-hardness materials. Do not use the baling press cylinder when the oil temperature exceeds 70 ° C.

When the baling press cylinder is in use, once the seal and guide support ring are found to be defective, the seal with the same structural form and appropriate material should be replaced according to the structural form of the baling press cylinder seal to be repaired, so as to minimize the thickness of the oil film between the seal and the sealing surface and reduce the leakage of the seal.

Answers to some questions about baling press cylinder:

The hydraulic cylinder is slow when moving forward and faster when moving back.
If the cylinder is single, it is slow when it is moving forward without the rod cavity, and fast when it is shrinking.

What is the relationship between medium cylinder and side cylinder ratio of forklift truck?
The middle cylinder and the side cylinder seem to have no relationship, as long as the lifting speed required by the design can be ensured, but the diameter of the cylinder can not be too thin, so as to avoid the middle cylinder acting first when the high gantry vibration lifting, and then the two cylinders acting again.