stacker cylinder Sold to Ecuador

This article mainly introduces:

Ecuador hydraulic cylinder,stacker cylinder manufacturer,stacker cylinder

(Ecuador stacker cylinder,produced by Hebei Hengyu company）

stacker cylinder are widely used in Ecuador，because of simple structure and reliable operation，excellent temperature resistance，no transmission clearance.So our company has designed stacker cylinder for customers from Ecuador.

Introduction to stacker cylinder:

If it is found that the stacker cylinder lubrication is poor or the stacker cylinder bore processing is abnormal, it is necessary to feedback the situation to the manufacturer, because the piston and the stacker cylinder, the guide rail and the piston rod have relative movement, if the lubrication is poor or the stacker cylinder bore is abnormal, it will aggravate the wear and reduce the straightness of the stacker cylinder center line. In this way, when the piston works in the stacker cylinder, the friction resistance will be large and small, resulting in slip or crawling. The solution is to repair and grind the stacker cylinder first, and then prepare the piston according to the matching requirements, repair and grind the piston rod, and configure the guide sleeve.

Before the stacker cylinder is removed, the relief valve should be loosened to reduce the pressure of the hydraulic circuit to zero, and then the power supply should be cut off to stop the hydraulic device. After loosening the oil port piping, the oil plug should be applied to plug the oil port.

The scar on the sliding surface of the stacker cylinder piston will transfer with use. Before the piston is installed, there are scars on its sliding surface, which are installed intact and untreated, and these scars will in turn scratch the inner surface of the stacker cylinder wall. Therefore, before installation, these scars must be fully repaired.

Because of the slightly complex structure of the buffer stacker cylinder, sometimes there will be problems, such as when the stacker cylinder with the buffer device is started in reverse, the piston often stops temporarily or reverses. Elimination method: The orifice of the check valve is too small, so that the amount of oil entering the buffer chamber is too small, and even a vacuum occurs, so the above fault phenomenon will occur when the buffer plunger leaves the end cover. In this regard, the orifice of the check valve should be increased.

Answers to some questions about stacker cylinder:

How to select the 2.5T bearing cylinder and hydraulic pump?
2,5 ton load is not heavy, you can use the rated pressure of 16 mpa gear pump, neither waste nor save cost, load/pressure = cylinder diameter, preset pressure of 8 mpa, 2500 (kg) /80 (bar) =31.25 square centimeters, in the open =63 mm, cylinder diameter can be selected 63 mm, stroke according to the situation, Hydraulic pump select gear pump, if there is a speed requirement, in order to calculate the displacement, the motor power also needs to determine the displacement of the pump to calculate.

What is the role of the cylinder on the plastic mold? The oil cylinder plays a great role in the mold, one is that the core distance is very large, or because of the mechanism of the product, only the oil cylinder is reasonable or more cost saving. Let the side core be extracted before opening the mold. Hot runner is mainly based on the product, sometimes customers require to use hot runner, the price is more expensive, but there are many benefits. It can save raw materials and shorten the molding cycle.