100 ton hydraulic cylinder Sold to Dominica

This article mainly introduces:

Dominica hydraulic cylinder,100 ton hydraulic cylinder manufacturer,100 ton hydraulic cylinder

(Dominica 100 ton hydraulic cylinder,produced by Hengyu Hydraulic Co., Ltd）

100 ton hydraulic cylinder are widely used in Dominica，because of high work efficiency，long service life，smooth movement.So our company has designed 100 ton hydraulic cylinder for customers from Dominica.

Introduction to 100 ton hydraulic cylinder:

When the long-stroke 100 ton hydraulic cylinder rotates horizontally, the piston rod bends due to its own weight, causing the guide sleeve and piston to produce biased load, resulting in 100 ton hydraulic cylinder head seal damage, oil leakage, and piston sleep in the 100 ton hydraulic cylinder. The following measures can be taken: increase the piston plan to adjust the piston outer circle and process it into a convex drum, so that the piston can self-position, improve the force situation, and reduce and avoid pulling the 100 ton hydraulic cylinder; The piston and the piston rod are connected with a spherical joint.

The machining accuracy of the 100 ton hydraulic cylinder depends on the level of equipment, production technology and testing means. 100 ton hydraulic cylinder processing methods are commonly used in two ways, one is rough boring - fine boring - rolling, generally with 45# seamless steel pipe, this method of processing quality is good, but the cost is high. Another method is to use 20# cold-drawn seamless steel pipe, and then honing, the cost is lower. The piston rod must be adjusted and straightened before processing, and the coating thickness of the piston rod is generally not less than 0.03mm. The piston must be machined in strict accordance with the groove size and tolerance requirements given in the seal manual.

The wear of the hard chromium plating layer of the 100 ton hydraulic cylinder is mostly caused by the grinding of the friction iron powder of the piston, and the wear is faster when there is water in the middle. Corrosion caused by the contact potential difference of the metal only occurs in the part of the piston contact, and the corrosion occurs in a point pattern. As mentioned above, when there is moisture in the middle, it will promote the development of corrosion. Compared with castings, the contact potential difference of copper alloy is higher, so the corrosion degree of copper alloy is more serious.

The 100 ton hydraulic cylinder is not the same as the 100 ton hydraulic cylinder, because the pressure of the pneumatic system is generally within the range of 0.2-1.0Mpa, the 100 ton hydraulic cylinder can not be used as a high-power power component, but the 100 ton hydraulic cylinder can be used as a relatively large power component, or the 100 ton hydraulic cylinder system can be used.

Answers to some questions about 100 ton hydraulic cylinder:

For a cylinder with a piston diameter of 100mm and a system pressure of 10MPa, what is the thrust?
Thrust is 7850 kg. Piston area A= πR^2=7850 square mm =78.5 square cm 10MPa = 100kg/cm^2 "^2" is square F = A x P =78.5 x 100=7850 kg.

What is the cause of the deep scratch of the cylinder?
The following reasons can cause the cylinder to be scratched. 1: Hydraulic oil containing particulate impurities into the hydraulic cylinder, these particulate impurities stuck between the piston rod and the guide ring (or stuck between the piston and the inner wall of the cylinder), when the piston movement in the cylinder will scratch the piston rod, the phenomenon of the inner wall of the cylinder, the more particles, the larger the scratch marks the deeper and more obvious. 2: The body of the cylinder itself. Due to assembly or design reasons, the coaxial error between the piston rod, piston, cylinder, guide ring and other parts is too large, or the cylinder, piston rod straightness error is too large, so that the piston rod and the guide ring interference between the cylinder, this mechanical interference will certainly lose the piston rod or cylinder wall.