supporting cylinder Sold to America

This article mainly introduces:

America hydraulic cylinder,supporting cylinder manufacturer,supporting cylinder

(America supporting cylinder,produced by Hengyu Group）

supporting cylinder are widely used in America，because of high work efficiency，long service life，smooth movement.So our company has designed supporting cylinder for customers from America.

Introduction to supporting cylinder:

Improve the service life of the supporting cylinder: it is necessary to maintain the normal clearance of the combined surface of the hydraulic components. When manufacturing or repairing the main parts of the supporting cylinder (such as the supporting cylinder block, piston rod, etc.), the assembly should be carried out in accordance with the tolerance lower limit of the assembly size, which can well reduce the occurrence of cavitation. If cavitation has occurred in the hydraulic components, only metallographic sandpaper polishing technology can be used to remove cavitation pitting and surface carbon deposits, and general fine sandpaper must not be used for polishing After the supporting cylinder is repaired, the hydraulic system should run smoothly for a certain period of time so that the hydraulic oil in the hydraulic system can be fully circulated; If necessary, the supporting cylinder inlet pipe (or return pipe) can be disassembled. Make the hydraulic oil overflow to achieve the effect of single supporting cylinder exhaust.

Regular maintenance of the supporting cylinder includes: regular tightening, supporting cylinder fastening screws and gland screws, supporting cylinder piston rod stop adjustment screws, should be tightened once a month, tighten each screw evenly, and achieve the corresponding tightening torque. Replace the seal regularly, it is recommended to replace the seal of the supporting cylinder once a year. Clean regularly, the supporting cylinder is cleaned every other year, and the seals are replaced while cleaning.

Piston supporting cylinder is widely used in hydraulic transmission. When the supporting cylinder works, it mainly delivers hydraulic oil alternately to both sides of the piston in the supporting cylinder, and uses the pressure difference of hydraulic oil on both sides of the piston to realize the reciprocating movement of the piston. If you want to speed up the forward speed of the piston, the return oil in the supporting cylinder can be controlled by the valve and directly input into the inlet pipe to participate in the work of the piston to achieve rapid movement of the piston, but the thrust of the piston is reduced much.

When the supporting cylinder is installed, it is necessary to ensure that the direction of the connecting head at the top of the piston rod should be consistent with the direction of the supporting cylinder head, earring (or middle hinge shaft), and ensure the straightness of the whole piston rod during the advance and return process to prevent rigid interference and cause unnecessary damage.

Answers to some questions about supporting cylinder:

When the superimposed hydraulic control valve is added to the bottom of a solenoid valve and a double directional throttle valve, why does the cylinder shock on the return trip?
The stack hydraulic control check valve must be added above the stack one-way throttle valve.

Do the collecting cylinder, distributing cylinder and distributing cylinder on the organic heat carrier boiler need to be notified separately as the pressure vessel for construction?
Do not need to be installed as a separate pressure vessel to inform, according to the organic heat carrier boiler can be informed. Write a "special equipment installation, renovation and maintenance notice" issued on it.