steering power cylinder Sold to Cameroon

This article mainly introduces:

Cameroon hydraulic cylinder,steering power cylinder manufacturer,steering power cylinder

(Cameroon steering power cylinder,produced by Hengyu Hydraulic Co., Ltd）

steering power cylinder are widely used in Cameroon，because of excellent fatigue and impact resistance，no need for deceleration device，long service life.So our company has designed steering power cylinder for customers from Cameroon.

Introduction to steering power cylinder:

When the steering power cylinder is repaired, its inner and outer diameter and roundness should be accurately measured. If the inner hole of the steering power cylinder is badly worn, it can be repaired by grinding the mandrel or honing on the boring machine. If the piston is worn, it can be repaired by electroplating, and serious wear should be replaced.

When the steering power cylinder is in use, once the seal and guide support ring are found to be defective, the seal with the same structural form and appropriate material should be replaced according to the structural form of the steering power cylinder seal to be repaired, so as to minimize the thickness of the oil film between the seal and the sealing surface and reduce the leakage of the seal.

Regular maintenance of the steering power cylinder includes: regular tightening, steering power cylinder fastening screws and gland screws, steering power cylinder piston rod stop adjustment screws, should be tightened once a month, tighten each screw evenly, and achieve the corresponding tightening torque. Replace the seal regularly, it is recommended to replace the seal of the steering power cylinder once a year. Clean regularly, the steering power cylinder is cleaned every other year, and the seals are replaced while cleaning.

When the steering power cylinder is installed, the piston and the steering power cylinder head and other parts have large mass, large size and large inertia, even if there is a lifting equipment auxiliary installation, because the specified clearance is small, no matter how hard it will be put into, therefore, the end of the piston or the steering power cylinder head boss is easy to cause scars when it hits the inner surface of the steering power cylinder wall. The solution to this problem: for a large number of small products, the use of autocratic assembly oriented tools during installation; For heavy, thick and large large and medium-sized steering power cylinders, only careful and careful operation can be avoided.

Answers to some questions about steering power cylinder:

What does the maximum output force of the cylinder piston mean?
The maximum output of the cylinder is related to the pressure of the hydraulic system that you link to the cylinder. For example, the rated maximum output thrust of the MOB 50 cylinder is 1.3 tons and the rated pressure is 7Mpa. That is, when the input hydraulic oil pressure of the cylinder reaches 7Mpa, the maximum output thrust of the cylinder is only 0.98 tons. When the input hydraulic pressure is only 5Mpa, the maximum output thrust of the cylinder is 1.3 tons. Because the pressure of the cylinder limit is only 7Mpa, if the oil pressure of the input system exceeds 7Mpa, the cylinder can not withstand the pressure burst, and it is damaged.

Why can't the hydraulic cylinder be replaced with water?
Hydraulic oil for hydraulic transmission has a variety of requirements for viscosity, density, flow rate, and temperature, which are not available for water.