cylinder with sensor Sold to Slovenia

This article mainly introduces:

Slovenia hydraulic cylinder,cylinder with sensor manufacturer,cylinder with sensor

(Slovenia cylinder with sensor,produced by Hengyu Group）

cylinder with sensor are widely used in Slovenia，because of smooth movement，no need for deceleration device，long service life.So our company has designed cylinder with sensor for customers from Slovenia.

Introduction to cylinder with sensor:

The scar on the sliding surface of the cylinder with sensor piston will transfer with use. Before the piston is installed, there are scars on its sliding surface, which are installed intact and untreated, and these scars will in turn scratch the inner surface of the cylinder with sensor wall. Therefore, before installation, these scars must be fully repaired.

How the cavitation of the cylinder with sensor is formed: With the gradual rise of pressure, the gas in the oil will become bubbles, when the pressure rises to a certain limit value, these bubbles will break under the action of high pressure, so that the high temperature and high pressure gas will quickly act on the surface of the parts, resulting in cavitation of the cylinder with sensor, resulting in corrosive damage to the parts.

The "O" ring can be used as an auxiliary seal inside the cylinder with sensor, and the elastic force of the "O" ring makes the sealing slip ring close to the sealing surface, generating sealing pressure to achieve sealing. When the internal hydraulic pressure increases, the "O" ring will further deform and squeeze the slip ring, thereby increasing the sealing pressure and improving the sealing performance. The structure has the characteristics of low friction coefficient, good wear resistance, automatic compensation for wear and absorption of hard particles in the cylinder with sensor, and can be completely sealed.

cylinder with sensor is the most important part of construction machinery, the traditional processing method is: broaching cylinder with sensor block - fine boring cylinder with sensor block - grinding cylinder with sensor block. The rolling method is: broaching cylinder with sensor block - fine boring cylinder with sensor block - rolling cylinder with sensor block, the process is 3 parts, but the time is compared: grinding 1 meter of the cylinder with sensor block is about 1-2 days, rolling 1 meter of the cylinder with sensor block is about 10-30 minutes. Input comparison: grinding machine or quilting machine (tens of thousands - millions), rolling knife (ten thousand - tens of thousands). After rolling, the surface roughness of the hole decreases from RA3.2-6.3 μm before rolling to Ra0.4 ~ 0.8μm, the surface hardness of the hole increases by about 30%, and the fatigue strength of the inner surface of the cylinder with sensor increases by 25%. If the cylinder with sensor life is only considered, it is increased by 2 to 3 times, and the boring and rolling process is 3 times more efficient than the grinding process In particular, if you want to make high-quality cylinder with sensors, you must take the rolling production process. After the cylinder with sensor is rolled, there is no sharp tiny edge on the surface, and long-term motion friction will not damage the seal ring or seal, which is particularly important in the hydraulic industry.

Answers to some questions about cylinder with sensor:

What is the main maintenance of the cylinder?
After disassembling the cylinder: 1, clean the cylinder and piston; 2, replace all seals; 3, if there is a valve to repair, to ensure sealing and flexible; 4, deal with all deformation parts; 5. Installation experiment.

What does cylinder speed ratio mean?
The speed ratio of the cylinder is the ratio of the reciprocating speed of the piston, equal to the ratio of the rodless cavity area to the roded cavity area.