displacement sensor cylinder Sold to The Philippines

This article mainly introduces:

The Philippines hydraulic cylinder,displacement sensor cylinder manufacturer,displacement sensor cylinder

(The Philippines displacement sensor cylinder,produced by Hengyu Hydraulic Cylinder Factory）

displacement sensor cylinder are widely used in The Philippines，because of excellent fatigue and impact resistance，no need for deceleration device，long service life.So our company has designed displacement sensor cylinder for customers from The Philippines.

Introduction to displacement sensor cylinder:

The daily inspection of the displacement sensor cylinder includes: checking the connection of the displacement sensor cylinder and the pipe joint for leaks. Check the displacement sensor cylinder rod for leaks. Check the displacement sensor cylinder connection for leaks. When the displacement sensor cylinder moves, the work is normal and smooth. Whether the displacement sensor cylinder has internal leakage.

displacement sensor cylinder can not drive the load troubleshooting: oil pressure is too low. displacement sensor cylinder selection specifications are too small. Leakage in displacement sensor cylinder or associated hydraulic system element.

We can not just consider the price and ignore the quality when we purchase the displacement sensor cylinders. Now some manufacturers produce unqualified products in order to reduce costs, the piston rod is not adjusted, the rod coating is not enough, the displacement sensor cylinder finish can not reach, the guide sleeve should use copper, but instead of ductile iron, although the cost is reduced, the quality of the displacement sensor cylinder is not required.

When installing the displacement sensor cylinder, the axial ends of the displacement sensor cylinder cannot be fixed. Due to the effect of liquid pressure and thermal expansion in the displacement sensor cylinder, there is axial expansion. If the two ends of the displacement sensor cylinder are fixed, all parts of the displacement sensor cylinder will be deformed. When disassembling the displacement sensor cylinder, it is strictly forbidden to hammer the displacement sensor cylinder and the piston surface, such as the displacement sensor cylinder hole and the piston surface is damaged, do not allow sandpaper grinding, to use a fine oil stone carefully grinding. The clearance between the guide sleeve and the piston rod should meet the requirements.

Answers to some questions about displacement sensor cylinder:

Design a hydraulic cylinder, the inner diameter of the cylinder is 100mm, what size of piston rod is best used?
This involves how much speed ratio you need, that is, the area ratio of the rod cavity and the rodless cavity, if the weight is relatively large, it is recommended that the speed ratio choose 2, that is, the piston rod diameter choose 70mm, under normal circumstances, the speed ratio choose 1.46, the piston rod diameter choose 55mm. Of course, there are many factors that affect the diameter of the piston rod, such as stroke, stroke is too long, in order to stabilize the work of the hydraulic cylinder, its diameter also needs to choose a relatively large, sometimes even non-standard products, need to choose according to the actual situation.

What is st represented in the cylinder formula?
St is the original unit of kinematic viscosity, the abbreviation of Stokes, that is, Stokes, short for S. cm2/s has now been used. 1 s (St) = 10^-4m2/s.