forklift tilting cylinder Sold to Uruguay

This article mainly introduces:

Uruguay hydraulic cylinder,forklift tilting cylinder manufacturer,forklift tilting cylinder

(Uruguay forklift tilting cylinder,produced by Hebei Hengyu company）

forklift tilting cylinder are widely used in Uruguay，because of excellent fatigue and impact resistance，smooth movement，high work efficiency.So our company has designed forklift tilting cylinder for customers from Uruguay.

Introduction to forklift tilting cylinder:

The material of the sliding part of the forklift tilting cylinder piston sintered casting piston will cause sintering phenomenon when subjected to large transverse load. In this case, the sliding part of the piston should be made of copper alloy or welded to such material.

forklift tilting cylinder head explanation: low pressure castings, medium and low pressure with HT300 gray iron, medium and high pressure with 35, 45 steel. When the forklift tilting cylinder head itself is the guide sleeve of the piston rod, the forklift tilting cylinder head is best cast iron. At the same time, brass, bronze or other wear-resistant materials should be fused on the guide surface. If the guide sleeve is pressed into the forklift tilting cylinder head, the guide sleeve shall be wear-resistant cast iron, bronze or brass.

Before the forklift tilting cylinder is removed, the relief valve should be loosened to reduce the pressure of the hydraulic circuit to zero, and then the power supply should be cut off to stop the hydraulic device. After loosening the oil port piping, the oil plug should be applied to plug the oil port.

When purchasing the forklift tilting cylinder, try to clarify the following parameters of the forklift tilting cylinder: A. forklift tilting cylinder diameter, rod diameter, stroke; B. Working pressure or forklift tilting cylinder load; C. Working environment temperature; D. Working medium; E. Operating speed; F. Other parameters, such as connection form, mounting size, etc. In this way, the right forklift tilting cylinder type can be found accurately and quickly.

Answers to some questions about forklift tilting cylinder:

What diameter cylinder is needed for a force of 5 tons?
It depends on the pressure of your system pump. If the normal working pressure of the system is about 8MPa, then the diameter of the cylinder should be 100 mm.

How to calculate the inner diameter of the hydraulic cylinder?
These two parameters need the following information to decide: 1, pump displacement, speed (to get the actual output flow of the pump) 2, three and time requirements (lift time, drop time takes a few seconds) and then view the close cylinder series according to the results. Select the right cylinder.