jacking hydraulic cylinder Sold to Latvia

This article mainly introduces:

Latvia hydraulic cylinder,jacking hydraulic cylinder manufacturer,jacking hydraulic cylinder

(Latvia jacking hydraulic cylinder,produced by Hengyu Group）

jacking hydraulic cylinder are widely used in Latvia，because of powerful torque，clever hydraulic energy conversion，simple structure and reliable operation.So our company has designed jacking hydraulic cylinder for customers from Latvia.

Introduction to jacking hydraulic cylinder:

After chrome plating of the piston rod of the jacking hydraulic cylinder, the surface flatness is not fully treated: After chrome plating of the piston rod surface, the method of post-plating polishing should be changed to post-plating polishing. Although it is necessary to increase the thickness of the coating before grinding (generally increased by about 0.02 in the diameter direction), it can remove chrome plating defects well, and test the binding force of the coating. In addition, due to the micro-roughness of the grinding surface, the trough can store lubricating oil, which can improve the wear resistance and extend the service life.

The method of sleeve jacking hydraulic cylinder to improve the processing quality: there is a big gap in the service life of post-plating polishing and post-plating polishing, especially in mass production. Strictly clean the flying edge and burr of mechanical components, especially the edge of the sealing groove, and the tiny metal burr, strictly clean before assembly. The surface fatigue strength and stress corrosion resistance of the jacking hydraulic cylinder can be significantly improved by rolling in the finishing of the inner holes of the jacking hydraulic cylinder. The roughness of the surface of the friction pair is generally controlled between Ra0.4 and 0.8.

The scar on the sliding surface of the jacking hydraulic cylinder piston will transfer with use. Before the piston is installed, there are scars on its sliding surface, which are installed intact and untreated, and these scars will in turn scratch the inner surface of the jacking hydraulic cylinder wall. Therefore, before installation, these scars must be fully repaired.

There are some honeycomb holes in the inner wall of the jacking hydraulic cylinder, piston or piston rod surface. How is this formed? When we repair the jacking hydraulic cylinder, we can see that there are some honeycomb holes on the inner wall of the jacking hydraulic cylinder, the piston or the piston rod surface, which are caused by cavitation. Therefore, the cavitation of the jacking hydraulic cylinder is targeted to prevent. Is very necessary.

Answers to some questions about jacking hydraulic cylinder:

What is the role of the cylinder on the plastic mold? The oil cylinder plays a great role in the mold, one is that the core distance is very large, or because of the mechanism of the product, only the oil cylinder is reasonable or more cost saving. Let the side core be extracted before opening the mold. Hot runner is mainly based on the product, sometimes customers require to use hot runner, the price is more expensive, but there are many benefits. It can save raw materials and shorten the molding cycle.

The two cylinders of the bending machine are out of sync?
Check whether the sliding slide is worn, adjust its tightness, so that both sides are consistent, check whether the two cylinder tubing is connected, tighten the flow valve, pressure, let the cylinder air discharge.