forklift cylinder Sold to Estonia

This article mainly introduces:

Estonia hydraulic cylinder,forklift cylinder manufacturer,forklift cylinder

(Estonia forklift cylinder,produced by Hengyu Group）

forklift cylinder are widely used in Estonia，because of no transmission clearance，long service life，smooth movement.So our company has designed forklift cylinder for customers from Estonia.

Introduction to forklift cylinder:

When the forklift cylinder is installed on the main engine, the oil port piping part and the guide sleeve should be checked for oil leakage in the running test, and the earring and the middle hinge shaft bearing should be refueled.

When the oil pressure of the forklift cylinder inlet is too low to reach the specified value, the leakage situation of the relevant oil system should be checked and the leakage should be eliminated; Check the piston and piston rod seal ring for damage, aging, loose and other phenomena; Check whether the hydraulic pump and pressure valve are faulty.

When the forklift cylinder is in use, measures should be added to prevent the intrusion of pollutants. Effective measures should be taken to control the intrusion of pollutants, such as installing high-efficiency air filters in the tank breathing holes, new oil must be filtered, etc., but also must improve the anti-pollution ability of the forklift cylinder itself. In the seriously polluted environment, it is more important to pay attention to, such as the underground oil forklift cylinder should use fluorine rubber (FRM) and nitrile rubber (NBR) dust ring, and the ground mechanical forklift cylinder should use nitrile rubber dust ring; The filter device is added to the oil inlet of the forklift cylinder of the dump truck, construction machinery, work platform and other equipment, and in order to reduce the oil inlet resistance, the flow area should be increased as much as possible, which can effectively reduce the particle pollution from the system.

The scar on the sliding surface of the forklift cylinder piston will transfer with use. Before the piston is installed, there are scars on its sliding surface, which are installed intact and untreated, and these scars will in turn scratch the inner surface of the forklift cylinder wall. Therefore, before installation, these scars must be fully repaired.

Answers to some questions about forklift cylinder:

How many kilograms can the 63 cylinder hold?
The force of the cylinder is related to the cylinder diameter and pressure. 63 cylinder diameter (cylinder inner circle diameter), 21MPA pressure, thrust 6 tons.

Can multiple identical hydraulic cylinders be supplied with the same supply line?
This can be connected, but there is a disadvantage, that is, the hydraulic cylinder with the minimum pressure is extended first, and then the pressure is higher, and then the higher, until all the hydraulic cylinders are extended, which may not meet the requirements of field use.