300 tons hydrauli ccylinder Sold to Australia

This article mainly introduces:

Australia hydraulic cylinder,300 tons hydrauli ccylinder manufacturer,300 tons hydrauli ccylinder

(Australia 300 tons hydrauli ccylinder,produced by Hengyu Hydraulic Cylinder Factory）

300 tons hydrauli ccylinder are widely used in Australia，because of high work efficiency，excellent fatigue and impact resistance，no need for deceleration device.So our company has designed 300 tons hydrauli ccylinder for customers from Australia.

Introduction to 300 tons hydrauli ccylinder:

300 tons hydrauli ccylinders in series, parallel and series parallel. Series: In the 300 tons hydrauli ccylinder, the oil inlet of the subsequent reversing valve is the supply of the previous oil return, and there is no separate oil return circuit connected with the oil return in each valve. Series: In the 300 tons hydrauli ccylinder, the oil inlet of the subsequent reversing valve is the supply of the previous oil return, and there is no separate oil return circuit connected with the oil return in each valve. Parallel: the pressure oil in the 300 tons hydrauli ccylinder is connected with the inlet oil of each reversing valve, and the return oil is collected by the return oil circuit. Series parallel: For this one, compared with the simple series and parallel, it is slightly more complicated, but it is not impossible to understand. The series refers to the oil in the 300 tons hydrauli ccylinder, which is in series form, but can not form a series circuit, and the parallel refers to the oil return circuit of each valve, which is in parallel.

The 300 tons hydrauli ccylinder should be used as far as possible to avoid the transverse force, sometimes the piston rod to bear the transverse load is too large, especially do not force or pull the 300 tons hydrauli ccylinder, bite. Elimination method: When installing the 300 tons hydrauli ccylinder, ensure that the axis position of the 300 tons hydrauli ccylinder is consistent with the direction of movement; Make the load borne by the 300 tons hydrauli ccylinder as far as possible through the 300 tons hydrauli ccylinder axis, to avoid the phenomenon of eccentricity.

Classification of 300 tons hydrauli ccylinder: according to the mode of movement it can be divided into linear reciprocating movement type and rotary swing type; According to the effect of liquid pressure, it can be divided into single acting type and double acting type. According to the structure, it can be divided into piston type, plunger type, multistage telescopic sleeve type, pinion and rack type, etc. According to the installation form can be divided into rod, earring, foot, hinge shaft and so on; According to the pressure grade can be divided into 16Mpa, 25Mpa, 31.5Mpa and so on.

The 300 tons hydrauli ccylinder can not be used as grounding electrode to avoid electric damage to the piston rod.

Answers to some questions about 300 tons hydrauli ccylinder:

How is the hydraulic cylinder selected in the mechanical design manual?
First of all, it is necessary to meet your work needs, and the second is to meet the structural space of the cylinder and accessories. Three to consider the other parameters of the cylinder.

Why does the hydraulic cylinder ring?
1 Air intrusion into the hydraulic system is the main reason for noise 2 The relief valve is unstable, such as due to the improper combination of the slide valve and the valve hole or the contact of the cone valve and the seat is stuck by dirt, the damping hole is blocked, the spring is crooked or fails to make the spool stuck or move in the valve hole, causing system pressure fluctuation and noise. 3 Improper adjustment of the reversing valve causes the spool of the reversing valve to move too fast, resulting in reversing impact, resulting in noise and vibration. 4 Mechanical vibration, such as long tubing, elbow more and not fixed, when the oil flow through, especially when the flow rate is high, easy to cause pipe shaking; The rotating part of the motor and hydraulic pump is unbalanced, or the alignment is not good during installation, or the coupling is loose, etc., which can produce vibration and noise.