baling press cylinder Sold to S.Africa

This article mainly introduces:

S.Africa hydraulic cylinder,baling press cylinder manufacturer,baling press cylinder

(S.Africa baling press cylinder,produced by Hengyu Hydraulic Co., Ltd）

baling press cylinder are widely used in S.Africa，because of excellent fatigue and impact resistance，no need for deceleration device，long service life.So our company has designed baling press cylinder for customers from S.Africa.

Introduction to baling press cylinder:

Regular maintenance of the baling press cylinder includes: regular tightening, baling press cylinder fastening screws and gland screws, baling press cylinder piston rod stop adjustment screws, should be tightened once a month, tighten each screw evenly, and achieve the corresponding tightening torque. Replace the seal regularly, it is recommended to replace the seal of the baling press cylinder once a year. Clean regularly, the baling press cylinder is cleaned every other year, and the seals are replaced while cleaning.

There are some honeycomb holes in the inner wall of the baling press cylinder, piston or piston rod surface. How is this formed? When we repair the baling press cylinder, we can see that there are some honeycomb holes on the inner wall of the baling press cylinder, the piston or the piston rod surface, which are caused by cavitation. Therefore, the cavitation of the baling press cylinder is targeted to prevent. Is very necessary.

When installing the baling press cylinder, the axial ends of the baling press cylinder cannot be fixed. Due to the effect of liquid pressure and thermal expansion in the baling press cylinder, there is axial expansion. If the two ends of the baling press cylinder are fixed, all parts of the baling press cylinder will be deformed. When disassembling the baling press cylinder, it is strictly forbidden to hammer the baling press cylinder and the piston surface, such as the baling press cylinder hole and the piston surface is damaged, do not allow sandpaper grinding, to use a fine oil stone carefully grinding. The clearance between the guide sleeve and the piston rod should meet the requirements.

baling press cylinder daily maintenance, should focus on checking whether the piston rod surface roughness and shape and position tolerance meet the technical requirements, if the piston rod bending should be calibrated to meet the requirements or according to the physical mapping, manufactured by a professional manufacturer. If the piston rod surface coating wear, slip damage, local spalling can be adopted to remove the coating, re-chrome surface processing process.

Answers to some questions about baling press cylinder:

Why can't the hydraulic cylinder be replaced with water?
Hydraulic oil for hydraulic transmission has a variety of requirements for viscosity, density, flow rate, and temperature, which are not available for water.

How to distinguish the size of hydraulic cylinder cavity?
The hydraulic cylinder has a rod cavity and a rodless cavity. The rod cavity is the cavity that the piston rod extends out. The rod cavity is of course small due to the existence of the piston rod. That's just relative.