garbage truck hydraulic cylinder Sold to Costa Rica

This article mainly introduces:

Costa Rica hydraulic cylinder,garbage truck hydraulic cylinder manufacturer,garbage truck hydraulic cylinder

(Costa Rica garbage truck hydraulic cylinder,produced by Hebei Hengyu company）

garbage truck hydraulic cylinder are widely used in Costa Rica，because of powerful torque，clever hydraulic energy conversion，simple structure and reliable operation.So our company has designed garbage truck hydraulic cylinder for customers from Costa Rica.

Introduction to garbage truck hydraulic cylinder:

The coordination of the sliding parts of the garbage truck hydraulic cylinder itself should not be too tight, the sealing friction force should not be too large, and H8 / f8 coordination should be selected between the piston rod and the guide sleeve; Check whether the size of the sealing ring is processed strictly according to the standard; If the V-shaped sealing ring is used, the sealing friction should be adjusted to a moderate degree.

There are some honeycomb holes in the inner wall of the garbage truck hydraulic cylinder, piston or piston rod surface. How is this formed? When we repair the garbage truck hydraulic cylinder, we can see that there are some honeycomb holes on the inner wall of the garbage truck hydraulic cylinder, the piston or the piston rod surface, which are caused by cavitation. Therefore, the cavitation of the garbage truck hydraulic cylinder is targeted to prevent. Is very necessary.

The garbage truck hydraulic cylinder requires that the filtration accuracy of the system is not less than the 80um, and the oil pollution should be strictly controlled, the oil should be kept clean, the performance of the oil should be checked regularly, and the necessary fine filtration and replacement of new working oil should be carried out.

Factors that should be considered when selecting the oil seal in the garbage truck hydraulic cylinder: some specific factors should be taken into account when selecting the oil seal in the garbage truck hydraulic cylinder, so as to have correct consideration and get accurate results, and then avoid wrong selection. The factors and aspects that should be taken into account are eight: garbage truck hydraulic cylinder diameter, piston rod diameter, piston rod and piston groove size, garbage truck hydraulic cylinder working pressure, garbage truck hydraulic cylinder movement speed, hydraulic system oil temperature and garbage truck hydraulic cylinder working environment.

Answers to some questions about garbage truck hydraulic cylinder:

What hydraulic oil does servo cylinder generally use?
The medium used by the cylinder generally depends on the working condition of the use, including pressure, installation environment, sealing material, etc. I think the first thing to consider is the impact of the sealing material. Mineral oil is a good choice if it is not too fire-resistant or used in a high temperature environment. 1, servo cylinder features: closed-loop servo control, control accuracy of 0.01mm; Precise control of thrust, increase pressure sensor, control accuracy up to 1%; It is easy to connect with PLC and other control systems to achieve high precision motion control. Low noise, energy saving, clean, high rigidity, impact resistance, long life, simple operation and maintenance. 2, the servo cylinder can be fault-free in harsh environments, and the protection level can reach IP66.

How to calculate hydraulic cylinder thrust?
Cylinder diameter = piston diameter =200MM Piston area =π (200/2) square =3140 square mm =31.4 square cm 25MPA=250KG/ square cm Maximum thrust = pressure * Piston area =250 *31.4 =7850KG=78500 Newtons This is the maximum thrust. The formula can be derived from the calculation formula.