shearing machine cylinder Sold to Japan

This article mainly introduces:

Japan hydraulic cylinder,shearing machine cylinder manufacturer,shearing machine cylinder

(Japan shearing machine cylinder,produced by Hengyu Hydraulic Co., Ltd）

shearing machine cylinder are widely used in Japan，because of smooth movement，excellent fatigue and impact resistance，high work efficiency.So our company has designed shearing machine cylinder for customers from Japan.

Introduction to shearing machine cylinder:

In order to ensure the service life of the shearing machine cylinder, the medium used must not be mixed with impurities and stolen goods, so as to avoid scratching the inner arm of the shearing machine cylinder, causing damage to the seal and causing leakage in the shearing machine cylinder. It is required that the filtration accuracy of the system is not less than 80μm, the oil pollution is strictly controlled, the hydraulic oil is kept clean, the performance of the hydraulic oil is regularly checked, and the necessary fine filtration or replacement of the new working hydraulic oil is carried out.

shearing machine cylinder installation precautions: Before installing the shearing machine cylinder into the system, the parameters on the shearing machine cylinder label should be compared with the parameters when ordering. The base of the shearing machine cylinder must have sufficient stiffness, otherwise the shearing machine cylinder will bend upward into a bow when pressurized, so that the piston rod will bend.

There are some honeycomb holes in the inner wall of the shearing machine cylinder, piston or piston rod surface. How is this formed? When we repair the shearing machine cylinder, we can see that there are some honeycomb holes on the inner wall of the shearing machine cylinder, the piston or the piston rod surface, which are caused by cavitation. Therefore, the cavitation of the shearing machine cylinder is targeted to prevent. Is very necessary.

shearing machine cylinder spool stuck or valve hole blocked How to solve: When the flow valve or direction valve spool stuck or valve hole blocked, the shearing machine cylinder prone to misoperation or action failure. At this time, the contamination of the oil should be checked; Check whether dirt or colloidal deposits are stuck in the spool or blocking the valve hole; Check the wear of the valve body, clean and replace the system filter, clean the fuel tank, and replace the hydraulic medium.

Answers to some questions about shearing machine cylinder:

What are the cylinder manufacturing processes?
Hydraulic cylinder processing process: 1, cylinder: a, material preparation (seamless steel pipe) → inspection (material certificate, etc.) → tempering (outsourcing: Some parts) → car (car round, shelf mouth, boring, flange stop, etc.) → tempered hardness test → welding (welded pipe joint base, flange and other accessories) → boring or honing (rough boring, fine boring, rolling) → car (hole slot or internal and external thread) → fitter (drilling) → inspection → rust prevention storage b, material preparation (forgings) → inspection (material certificate, inspection, etc.) → welding (blank butt welding) → welding inspection → car (rough car) → quality control (outsourcing: some parts) → car (car round, shelf mouth, boring stop, flange stop, etc.)

How does the hydraulic solenoid valve realize that the cylinder stops at any position?
Use an O-type medium function solenoid directional valve, or use a Y-type solenoid directional valve and a hydraulically controlled check valve.