track steering cylinder Sold to Paraguay

This article mainly introduces:

Paraguay hydraulic cylinder,track steering cylinder manufacturer,track steering cylinder

(Paraguay track steering cylinder,produced by Hengyu Hydraulic Co., Ltd）

track steering cylinder are widely used in Paraguay，because of no need for deceleration device，long service life，smooth movement.So our company has designed track steering cylinder for customers from Paraguay.

Introduction to track steering cylinder:

Do not enter foreign bodies when installing the track steering cylinder block. The place where the installation operation is carried out, the conditions are not good, and foreign bodies can be entered unconsciously. Therefore, the installation site must be cleaned up around, especially the place where the parts are placed must be cleaned, so that there is no dirt.

The track steering cylinder can not be used as grounding electrode to avoid electric damage to the piston rod.

track steering cylinder can not drive the load troubleshooting: oil pressure is too low. track steering cylinder selection specifications are too small. Leakage in track steering cylinder or associated hydraulic system element.

track steering cylinder body inspection: The inner surface of the track steering cylinder and the piston seal are the main factors causing the leakage in the track steering cylinder, if the track steering cylinder has a longitudinal tensile mark, even if the new piston seal is replaced, it can not effectively eliminate the fault, the inner surface of the track steering cylinder mainly checks whether the dimensional tolerance and shape and position tolerance meet the technical requirements, there is no longitudinal tensile mark, and measures the depth of the longitudinal tensile mark, in order to take the corresponding solution.

Answers to some questions about track steering cylinder:

Where is the tension cylinder used in the excavator?
Get off the inside of the frame, behind the guide wheel (steering wheel, guide wheel). Disassemble the track and take the guide wheel out to see the tensioning cylinder (track spring).

How to calculate the tonnage of the hydraulic press without konowing the diameter of the cylinder?
To know the tonnage of the hydraulic cylinder, you first need to know the working pressure of the hydraulic system, the inner diameter of the hydraulic cylinder and the outer diameter of the cylinder rod (the outer diameter of the cylinder rod is needed when calculating the hydraulic cylinder tension). The thrust of the hydraulic cylinder (that is, the force that the hydraulic cylinder can produce by extending out) = the cross-sectional area of the hydraulic cylinder (or the cross-sectional area of the piston) × the working pressure of the cylinder (the cross-sectional area of the piston) =pi*D^2/4= PI (take 3.14) × the square of the cross-sectional area of the piston ÷4 working pressure to see the pressure displayed on the pressure gauge when the maximum load is working.