vehicle hydraulic cylinder Sold to Morocco

This article mainly introduces:

Morocco hydraulic cylinder,vehicle hydraulic cylinder manufacturer,vehicle hydraulic cylinder

(Morocco vehicle hydraulic cylinder,produced by Hengyu Hydraulic Cylinder Factory）

vehicle hydraulic cylinder are widely used in Morocco，because of excellent fatigue and impact resistance，excellent temperature resistance，simple structure and reliable operation.So our company has designed vehicle hydraulic cylinder for customers from Morocco.

Introduction to vehicle hydraulic cylinder:

vehicle hydraulic cylinder can not drive the load troubleshooting: oil pressure is too low. vehicle hydraulic cylinder selection specifications are too small. Leakage in vehicle hydraulic cylinder or associated hydraulic system element.

The pressure, temperature, medium and speed of different types of seals are not the same, water-ethylene glycol medium (HFC) can not be sealed with polyurethane, it can only use rubber seal; When the vehicle hydraulic cylinder is running fast, it must be sealed with slip ring, such as Sterseal, Glairing, GD1000K, TDI, etc., when the running speed is slow, Yx, U, V combination seals can be used; Fluorine rubber seal is used in high temperature and high pressure environment; When the running speed is fast, the buffer sleeve and buffer valve must be considered.

The meaning of the vehicle hydraulic cylinder model marked by the vehicle hydraulic cylinder manufacturer: for example, 160/100-1150, its meaning: from a professional point of view, 160 refers to the vehicle hydraulic cylinder diameter, which is 160mm, and the 100 behind refers to the rod diameter, which is 100mm. The 1150 refers to the vehicle hydraulic cylinder stroke, which is 1150mm. Therefore, on this point, we should have a correct understanding and can not make mistakes.

The scar on the sliding surface of the vehicle hydraulic cylinder piston will transfer with use. Before the piston is installed, there are scars on its sliding surface, which are installed intact and untreated, and these scars will in turn scratch the inner surface of the vehicle hydraulic cylinder wall. Therefore, before installation, these scars must be fully repaired.

Answers to some questions about vehicle hydraulic cylinder:

When the hydraulic cylinder changes from fast to slow, how can the slow speed become more even and the speed can be adjusted?
Reversing valve set 2 reversing valves. The back of one valve goes directly to the cylinder, running at full speed for fast action. Add a speed control valve behind the other valve, and then connect to the cylinder to achieve slow action, you can adjust the opening of the speed control valve, to achieve the speed of the cylinder can be adjusted. An import speed control valve to more than 1,000 yuan, if you think it is too expensive, you can also use the throttle valve instead. However, the throttle valve is greatly affected by the load change.

How to repair the bent oil cylinder correctly?
If the bending oil cylinder leaks, the most direct way is to replace the seal ring. Most of the sealing rings used by domestic bending machines are made in Taiwan and Japan, so the service life of the sealing ring is still relatively long. If the bending oil cylinder used by the customer leaks oil, then when replacing the seal ring, be sure to choose a high-quality and durable seal ring. In this way, the replaced cylinder will not leak oil for a long time.