electromagnetic induction cylinder Sold to Norway

This article mainly introduces:

Norway hydraulic cylinder,electromagnetic induction cylinder manufacturer,electromagnetic induction cylinder

(Norway electromagnetic induction cylinder,produced by Hebei Hengyu company）

electromagnetic induction cylinder are widely used in Norway，because of clever hydraulic energy conversion，simple structure and reliable operation，excellent temperature resistance.So our company has designed electromagnetic induction cylinder for customers from Norway.

Introduction to electromagnetic induction cylinder:

Classification of electromagnetic induction cylinder: according to the mode of movement it can be divided into linear reciprocating movement type and rotary swing type; According to the effect of liquid pressure, it can be divided into single acting type and double acting type. According to the structure, it can be divided into piston type, plunger type, multistage telescopic sleeve type, pinion and rack type, etc. According to the installation form can be divided into rod, earring, foot, hinge shaft and so on; According to the pressure grade can be divided into 16Mpa, 25Mpa, 31.5Mpa and so on.

In the hydraulic system, sometimes the inner layer of the rubber hose is peeled off, so that the oil circuit is on and off, resulting in irregular electromagnetic induction cylinder action. Troubleshooting method: Replace the rubber hose.

When purchasing the electromagnetic induction cylinder, try to clarify the following parameters of the electromagnetic induction cylinder: A. electromagnetic induction cylinder diameter, rod diameter, stroke; B. Working pressure or electromagnetic induction cylinder load; C. Working environment temperature; D. Working medium; E. Operating speed; F. Other parameters, such as connection form, mounting size, etc. In this way, the right electromagnetic induction cylinder type can be found accurately and quickly.

If the piston rod and electromagnetic induction cylinder are stuck or the electromagnetic induction cylinder is blocked, at this time, no matter how to operate, the electromagnetic induction cylinder does not move or has little action. At this time, check whether the piston and piston rod seal is too tight, whether it enters the dirt and gum deposits: whether the shaft line of the piston rod and the electromagnetic induction cylinder is in the center, whether the wearing parts and seals are invalid, and whether the load is too large.

Answers to some questions about electromagnetic induction cylinder:

Why can't the hydraulic cylinder be pulled back after pushing to the limit?
May be long-term use to the limit position, resulting in serious wear caused! The solution is to add the stroke switch or disassemble and add gaskets before and after the piston.

Two cylinders have a reversing control, if the load of the two cylinders is not the same, how to ensure their synchronization?
The piston rod of the cylinder is required to extend synchronization: install A shunt collector valve or synchronous motor at port A of the direction control valve, and then connect the two outlets of the shunt collector valve to the rod-free cavity of the two cylinders respectively. It is required that the outlet of the diverter collector valve is connected to the rod cavity of the two cylinders respectively when the piston rod is withdrawn in synchronization. The synchronization performance depends on the quality of the diverter valve and the leakage of the hydraulic system.