fig support cylinder Sold to Luxembourg

This article mainly introduces:

Luxembourg hydraulic cylinder,fig support cylinder manufacturer,fig support cylinder

(Luxembourg fig support cylinder,produced by Hengyu Group）

fig support cylinder are widely used in Luxembourg，because of long service life，excellent fatigue and impact resistance，no need for deceleration device.So our company has designed fig support cylinder for customers from Luxembourg.

Introduction to fig support cylinder:

If the seal of the fig support cylinder is softened and sticky, it may be that the seal is incompatible with the hydraulic oil or the nearby lubricating oil, replace the appropriate seal; If the seal becomes hard and loses elasticity, most of it is because the ambient temperature is too high (more than 80 ° C), make appropriate temperature insulation protection or replace the high temperature seal.

The daily inspection of the fig support cylinder includes: checking the connection of the fig support cylinder and the pipe joint for leaks. Check the fig support cylinder rod for leaks. Check the fig support cylinder connection for leaks. When the fig support cylinder moves, the work is normal and smooth. Whether the fig support cylinder has internal leakage.

The piston rod and guide sleeve function of the fig support cylinder is crucial: the relative motion pair between the piston rod and the guide sleeve is the main factor causing external leakage, if the chrome layer on the surface of the piston rod is spalling or producing longitudinal tensile marks due to wear, it will directly lead to the failure of the seal.

Classification of fig support cylinder: according to the mode of movement it can be divided into linear reciprocating movement type and rotary swing type; According to the effect of liquid pressure, it can be divided into single acting type and double acting type. According to the structure, it can be divided into piston type, plunger type, multistage telescopic sleeve type, pinion and rack type, etc. According to the installation form can be divided into rod, earring, foot, hinge shaft and so on; According to the pressure grade can be divided into 16Mpa, 25Mpa, 31.5Mpa and so on.

Answers to some questions about fig support cylinder:

How many kilograms can the 63 cylinder hold?
The force of the cylinder is related to the cylinder diameter and pressure. 63 cylinder diameter (cylinder inner circle diameter), 21MPA pressure, thrust 6 tons.

How big is the 100t cylinder pump and how big is the motor?
Load is calculated at 15 tons, stroke is calculated at 100 (both take the maximum) 15 tons = 15,000 kg, 15,000/210 bar (21 mpa) =71.42 square centimeters (cylinder area) 71.42/3,14 In the root *2=90,5 the inner diameter of the cylinder can be taken 100 mm. Travel 100 cm, that is, one meter, assuming 10, seconds a back and forth, then it is six times a minute, six meters per minute, then the required flow is,71,42*600 cm (6 meters) =42840 mm =42.84 liters/minute 42.84*21/60=14.9 kilowatts can choose 1450 RPM 4-stage motor 15KW.