supporting cylinder Sold to The Philippines

This article mainly introduces:

The Philippines hydraulic cylinder,supporting cylinder manufacturer,supporting cylinder

(The Philippines supporting cylinder,produced by Hengyu Hydraulic Cylinder Factory）

supporting cylinder are widely used in The Philippines，because of long service life，smooth movement，high work efficiency.So our company has designed supporting cylinder for customers from The Philippines.

Introduction to supporting cylinder:

The supporting cylinder should be used correctly and maintained regularly. The supporting cylinder should be deflated before use, the buffer regulating valve should be adjusted to a reasonable position, the cleanliness of the oil should be checked regularly, the dust on the supporting cylinder should be cleaned regularly, and attention should be paid to waterproof and fireproof.

When the hydraulic oil is not pumped into the supporting cylinder, it is necessary to check whether the tubing, oil circuit, especially the hose joint has been blocked, and the relevant oil circuit from the supporting cylinder to the pump should be checked in turn and blocked; Check whether the seal between the taper valve and the seat of the relief valve is good; Check whether the solenoid valve spring is damaged or whether the solenoid coil is burned out; Whether the oil circuit is switched is insensitive.

supporting cylinder body inspection: The inner surface of the supporting cylinder and the piston seal are the main factors causing the leakage in the supporting cylinder, if the supporting cylinder has a longitudinal tensile mark, even if the new piston seal is replaced, it can not effectively eliminate the fault, the inner surface of the supporting cylinder mainly checks whether the dimensional tolerance and shape and position tolerance meet the technical requirements, there is no longitudinal tensile mark, and measures the depth of the longitudinal tensile mark, in order to take the corresponding solution.

When the piston speed of the supporting cylinder is high, the steel ball of the check valve flows with the oil flow, so that the valve hole is blocked, and the supporting cylinder moves irregularly. Elimination method: Replace the steel ball with a cone valve or spool with a guide shoulder.

Answers to some questions about supporting cylinder:

What do cylinder internal leakage and external leakage mean?
Internal leakage means that the piston seal in the cylinder is not strict, there is a leak between the two chambers of the cylinder, the oil is still in the cylinder, and the external leakage is that the oil leaks to the outside of the cylinder.

How many kinds of cylinder seal repair kit are there?
Very much, a wide variety of imported and domestic, J type, UHS, DHS, O-ring, Sterseal, etc., as well as support bars, materials are different, according to the size of the pressure selection is different, the appearance of the structure is different, the size is a variety, maintenance is generally selected according to the needs of the cylinder.