steering power cylinder Sold to Tanzania

This article mainly introduces:

Tanzania hydraulic cylinder,steering power cylinder manufacturer,steering power cylinder

(Tanzania steering power cylinder,produced by Hengyu Hydraulic Cylinder Factory）

steering power cylinder are widely used in Tanzania，because of high work efficiency，excellent fatigue and impact resistance，no need for deceleration device.So our company has designed steering power cylinder for customers from Tanzania.

Introduction to steering power cylinder:

The steering power cylinder requires that the filtration accuracy of the system is not less than the 80um, and the oil pollution should be strictly controlled, the oil should be kept clean, the performance of the oil should be checked regularly, and the necessary fine filtration and replacement of new working oil should be carried out.

The steering power cylinder is not the same as the steering power cylinder, because the pressure of the pneumatic system is generally within the range of 0.2-1.0Mpa, the steering power cylinder can not be used as a high-power power component, but the steering power cylinder can be used as a relatively large power component, or the steering power cylinder system can be used.

When the steering power cylinder is repaired, its inner and outer diameter and roundness should be accurately measured. If the inner hole of the steering power cylinder is badly worn, it can be repaired by grinding the mandrel or honing on the boring machine. If the piston is worn, it can be repaired by electroplating, and serious wear should be replaced.

Before the steering power cylinder is removed, the relief valve should be loosened to reduce the pressure of the hydraulic circuit to zero, and then the power supply should be cut off to stop the hydraulic device. After loosening the oil port piping, the oil plug should be applied to plug the oil port.

Answers to some questions about steering power cylinder:

What is the difference between hydraulic piston cylinder and plunger cylinder?
The force surface of the piston cylinder is a rod cavity and a rodless cavity, and the force surface of the plunger cylinder is the plunger, the spring return single-acting piston cylinder can also rely on the external force of the spring to achieve return, the double-acting piston cylinder can produce tension, and the plunger cylinder only produces thrust without tension.

Do the collecting cylinder, distributing cylinder and distributing cylinder on the organic heat carrier boiler need to be notified separately as the pressure vessel for construction?
Do not need to be installed as a separate pressure vessel to inform, according to the organic heat carrier boiler can be informed. Write a "special equipment installation, renovation and maintenance notice" issued on it.