reciprocating cylinder Sold to Uganda

This article mainly introduces:

Uganda hydraulic cylinder,reciprocating cylinder manufacturer,reciprocating cylinder

(Uganda reciprocating cylinder,produced by Hengyu Hydraulic Co., Ltd）

reciprocating cylinder are widely used in Uganda，because of long service life，smooth movement，high work efficiency.So our company has designed reciprocating cylinder for customers from Uganda.

Introduction to reciprocating cylinder:

The difference between the integral reciprocating cylinder and the split reciprocating cylinder: The integral reciprocating cylinder and the split reciprocating cylinder in the reciprocating cylinder are two different reciprocating cylinders, and they are very different. The whole reciprocating cylinder, which is cast in one body, is not prone to problems such as oil leakage; The split reciprocating cylinder is welded twice, so if it is not handled well at the welding, it is prone to problems such as oil leakage and reciprocating cylinder damage. Therefore, it is obvious that the answer to this question is for difference.

reciprocating cylinder piston sealing is best to use Yx ring, polyurethane and polytetrafluoroethylene sealing material combination, can significantly improve the sealing performance: (I), reduce friction resistance, no crawling phenomenon; (ii) Have good dynamic and static sealing, wear resistance, long service life; (iii) The installation groove is simple, and the disassembly is simple.

1, the hydraulic machinery should be kept clean, in order to prevent dust and debris from falling into the oil, the tank should be sealed. 2, the oil in the tank should be replaced regularly according to the working condition. When changing the oil, the dirt and impurities accumulated at the bottom of the tank should be removed and the tank should be cleaned. 3, hydraulic oil, oil drums should be set in a clean and safe place to strengthen management. The oil drum, oil filter, oil funnel, oil pipe, etc. used should be kept clean. The oil drums for loading hydraulic oil must be cleaned in advance, and the oil drums should be dedicated and not mixed with other oil drums.

Before the reciprocating cylinder is removed, the relief valve should be loosened to reduce the pressure of the hydraulic circuit to zero, and then the power supply should be cut off to stop the hydraulic device. After loosening the oil port piping, the oil plug should be applied to plug the oil port.

Answers to some questions about reciprocating cylinder:

Is a hydraulic cylinder and a jack the same thing?
Strictly speaking, no. Although the hydraulic principle is used, and even some of the longer jacks are similar to the cylinder, the internal structure of the two is different. There is a check valve inside the jack. After the top lift, the check valve locks the hydraulic oil circuit, and the hydraulic oil only enters and does not exit after the check valve locks, and can be lowered to complete a reciprocating movement. The cylinder is usually connected to the distribution tube to control the movement, and works with a wide variety of distribution valves and distribution systems according to different needs. The jack only needs a simple check valve.

What are the standard cylinder models for hydraulic cylinders?
National standard GB/T2348-1993 specifies the hydraulic cylinder inner diameter series, you can check GB/T2348-1993 relevant regulations.