magnetic ring induction cylinder Sold to Indonesia

This article mainly introduces:

Indonesia hydraulic cylinder,magnetic ring induction cylinder manufacturer,magnetic ring induction cylinder

(Indonesia magnetic ring induction cylinder,produced by Hengyu Hydraulic Cylinder Factory）

magnetic ring induction cylinder are widely used in Indonesia，because of high work efficiency，no need for deceleration device，excellent fatigue and impact resistance.So our company has designed magnetic ring induction cylinder for customers from Indonesia.

Introduction to magnetic ring induction cylinder:

Analysis of commonly used seals: The wear ring and slip ring commonly used on the magnetic ring induction cylinder are generally made of polytetrafluoroethylene + graphite, because pure polytetrafluoroethylene is easy to produce plastic creep, which is only suitable for low pressure and low wear resistance conditions. If the sealing ring used is a composite material formed after adding graphite filler, the performance can be effectively improved, the ability to resist plastic creep is increased by 2 to 3 times, the initial deformation caused by the load is reduced by 30 to 60% : the rigidity is increased by 2 to 3 times: the dimensional stability under heat is increased by 2 times, and the hardness is increased by l0 to 15%.

The magnetic ring induction cylinder requires that the filtration accuracy of the system is not less than the 80um, and the oil pollution should be strictly controlled, the oil should be kept clean, the performance of the oil should be checked regularly, and the necessary fine filtration and replacement of new working oil should be carried out.

The viscosity of the working oil used in the magnetic ring induction cylinder is 29~74mm2/S, and ISO VG46 anti-wear hydraulic oil is recommended. Working oil temperature within the range of -20~80. C. When the ambient temperature and service temperature are low, the oil with lower viscosity can be selected.

The daily inspection of the magnetic ring induction cylinder includes: checking the connection of the magnetic ring induction cylinder and the pipe joint for leaks. Check the magnetic ring induction cylinder rod for leaks. Check the magnetic ring induction cylinder connection for leaks. When the magnetic ring induction cylinder moves, the work is normal and smooth. Whether the magnetic ring induction cylinder has internal leakage.

Answers to some questions about magnetic ring induction cylinder:

When there is only one hole in the oil inlet and outlet of the hydraulic cylinder, will there be oil leakage?
It is a single acting oil cylinder. This oil cylinder is always driven by hydraulic oil in advance, and is generally pulled back by the spring at the bottom of the piston or the weight of the cylinder piston or the load. But either way, it has nothing to do with any internal leakage. Whether the oil is internally drained is related to the sealing and accuracy of the cylinder itself.

How to set up the one-way cylinder hydraulic system?
Single acting oil cylinder, that is, an oil cylinder with an oil port, can use two three-way valves to control the cylinder action. The three oil ports are respectively connected to P (oil pump), A (oil cylinder), and T (oil tank). If the oil pump is to run continuously, an electromagnetic relief valve can be added. When the cylinder is not moving, the relief valve can unload the oil pump. You can also add a three-way four-way valve, the middle function is unloaded, two outlets: A connected to the fuel tank, B connected to the cylinder.