plunger type cylinder Sold to Kenya

This article mainly introduces:

Kenya hydraulic cylinder,plunger type cylinder manufacturer,plunger type cylinder

(Kenya plunger type cylinder,produced by Hebei Hengyu company）

plunger type cylinder are widely used in Kenya，because of powerful torque，excellent temperature resistance，no transmission clearance.So our company has designed plunger type cylinder for customers from Kenya.

Introduction to plunger type cylinder:

The material, shape and compression of the plunger type cylinder seal have a great impact on the service life and work efficiency of the plunger type cylinder. In addition to requiring a reliable seal, it should also have a long service life and less friction loss. At present, there are many seal manufacturers in the country, and it is also crucial to choose high-quality seals with reliable and stable quality.

When installing the plunger type cylinder pipe, the pipe should be cleaned after installation, and should not pass through the plunger type cylinder block, and the by-pass pipe must be installed in front of the oil port of the plunger type cylinder block. This is important. Otherwise, the foreign body in the pipeline will enter the plunger type cylinder, and once it enters, it is difficult to exclude it, but it becomes a foreign body transported to the plunger type cylinder. Moreover, when cleaning, the removal method of foreign bodies entered in the installation pipeline operation should be considered. In addition, the corrosion in the pipe should be pickling and other procedures before the pipe installation, and the rust must be completely removed.

When the oil pressure of the plunger type cylinder inlet is too low to reach the specified value, the leakage situation of the relevant oil system should be checked and the leakage should be eliminated; Check the piston and piston rod seal ring for damage, aging, loose and other phenomena; Check whether the hydraulic pump and pressure valve are faulty.

If the plunger type cylinder piston rod is found to be worn, it can be brushed and plated first, then ground, and finally adjust the mating accuracy of the piston rod and the guide sleeve. At this time, the guide sleeve can be properly redrilled or the guide sleeve can be re-turned. When making the above repairs, remember to replace various rubber seals in time.

Answers to some questions about plunger type cylinder:

How big is the 100t cylinder pump and how big is the motor?
Load is calculated at 15 tons, stroke is calculated at 100 (both take the maximum) 15 tons = 15,000 kg, 15,000/210 bar (21 mpa) =71.42 square centimeters (cylinder area) 71.42/3,14 In the root *2=90,5 the inner diameter of the cylinder can be taken 100 mm. Travel 100 cm, that is, one meter, assuming 10, seconds a back and forth, then it is six times a minute, six meters per minute, then the required flow is,71,42*600 cm (6 meters) =42840 mm =42.84 liters/minute 42.84*21/60=14.9 kilowatts can choose 1450 RPM 4-stage motor 15KW.

What is the material of the hydraulic cylinder slider?
Three parts of the hydraulic cylinder are essential, which are: cylinder - cylinder head assembly, piston - piston rod assembly, and sealing device. When you say slider, you mean piston. - Piston rod. Piston materials commonly used gray cast iron, wear-resistant cast iron, aluminum alloy (assembled), etc., can also be used 35 and 45 steel (integral). The piston rod is generally made of 35 and 45 steel. When the impact vibration is large, alloy steel such as 55 steel or 40Cr is used.