steering cylinder Sold to Spain

This article mainly introduces:

Spain hydraulic cylinder,steering cylinder manufacturer,steering cylinder

(Spain steering cylinder,produced by Hengyu Group）

steering cylinder are widely used in Spain，because of simple structure and reliable operation，excellent temperature resistance，no transmission clearance.So our company has designed steering cylinder for customers from Spain.

Introduction to steering cylinder:

The wear of the hard chromium plating layer of the steering cylinder is mostly caused by the grinding of the friction iron powder of the piston, and the wear is faster when there is water in the middle. Corrosion caused by the contact potential difference of the metal only occurs in the part of the piston contact, and the corrosion occurs in a point pattern. As mentioned above, when there is moisture in the middle, it will promote the development of corrosion. Compared with castings, the contact potential difference of copper alloy is higher, so the corrosion degree of copper alloy is more serious.

steering cylinder diameter, rod diameter, stroke determination: Choose national standards or other standards steering cylinder, avoid the selection of non-standard size, otherwise the difficulty of processing and manufacturing costs will be increased. The length of the steering cylinder guide is determined by the length of the stroke. Check the strength of steering cylinder, piston rod, screw, etc. according to the working pressure or load. At the same time, working pressure, ambient temperature, working medium and running speed are also the key to selecting seals.

The difference between the plunger steering cylinder and the piston steering cylinder is that the piston in the steering cylinder is replaced by a shaft plunger, which is used in hydraulic transmission requiring a long mechanical stroke, and can only input pressure oil from one direction, pressurize in a single direction, and form a thrust to push the plunger to move. The return trip of the plunger depends on the plunger itself to fall, and some rely on the spring to push back to the original position. Usually used plunger type steering cylinder, its inner hole does not need mechanical finishing, as long as the plunger round grinding can be assembled.

steering cylinder can not drive the load troubleshooting: oil pressure is too low. steering cylinder selection specifications are too small. Leakage in steering cylinder or associated hydraulic system element.

Answers to some questions about steering cylinder:

How to calculate the hydraulic cylinder pressure, how much pressure can put up how much weight?
There is a formula for air pressure, hydraulic pressure, water pressure: F=P×S type: f-cylinder or hydraulic cylinder output, unit is Newton (N) P- pressure, unit is Mpa S- effective area, unit is square millimeter (mm2), note: is the effective area, in the hydraulic cylinder to subtract the cross-sectional area of the piston rod.

What is hydraulic cylinder guide?
The cylinder itself can not move, the piston moves, the guide should be used to guide the mechanism connected with the piston extension end. For example, in the commonly used hydraulic press, the guide column above is used to guide the pressure plate connected with the piston.