servo hydraulic cylinder Sold to Sudan

This article mainly introduces:

Sudan hydraulic cylinder,servo hydraulic cylinder manufacturer,servo hydraulic cylinder

(Sudan servo hydraulic cylinder,produced by Hengyu Group）

servo hydraulic cylinder are widely used in Sudan，because of simple structure and reliable operation，excellent fatigue and impact resistance，no need for deceleration device.So our company has designed servo hydraulic cylinder for customers from Sudan.

Introduction to servo hydraulic cylinder:

When purchasing the servo hydraulic cylinder, try to clarify the following parameters of the servo hydraulic cylinder: A. servo hydraulic cylinder diameter, rod diameter, stroke; B. Working pressure or servo hydraulic cylinder load; C. Working environment temperature; D. Working medium; E. Operating speed; F. Other parameters, such as connection form, mounting size, etc. In this way, the right servo hydraulic cylinder type can be found accurately and quickly.

The method of sleeve servo hydraulic cylinder to improve the processing quality: there is a big gap in the service life of post-plating polishing and post-plating polishing, especially in mass production. Strictly clean the flying edge and burr of mechanical components, especially the edge of the sealing groove, and the tiny metal burr, strictly clean before assembly. The surface fatigue strength and stress corrosion resistance of the servo hydraulic cylinder can be significantly improved by rolling in the finishing of the inner holes of the servo hydraulic cylinder. The roughness of the surface of the friction pair is generally controlled between Ra0.4 and 0.8.

Regular maintenance of the servo hydraulic cylinder includes: regular tightening, servo hydraulic cylinder fastening screws and gland screws, servo hydraulic cylinder piston rod stop adjustment screws, should be tightened once a month, tighten each screw evenly, and achieve the corresponding tightening torque. Replace the seal regularly, it is recommended to replace the seal of the servo hydraulic cylinder once a year. Clean regularly, the servo hydraulic cylinder is cleaned every other year, and the seals are replaced while cleaning.

The assembly work of the servo hydraulic cylinder has a great impact on the quality of the servo hydraulic cylinder: each part must be carefully cleaned before assembly; To correctly install the sealing device everywhere: when installing the sealing ring, pay attention to its installation direction to avoid oil leakage due to installation, and its lip should be equipped with a pressure oil chamber. In addition, because it is a YX-shaped sealing ring, it is necessary to pay attention to distinguish between shaft and hole use, do not install wrong; Because the sealing device is matched with the sliding surface, an appropriate amount of hydraulic oil should be applied during assembly; The special wrench should be used when the threaded coupling is tightened, and the torque should meet the standard requirements; After the piston and piston rod are assembled, it is necessary to measure whether the coaxiality and straightness on the full length are out of whack. After assembly, there should be no blocking sensation and uneven resistance when the piston assembly moves.

Answers to some questions about servo hydraulic cylinder:

How big is the motor and oil pump for the 80 cylinder?
Pump motor selection is not only related to cylinder diameter but also speed system, it is recommended to provide system diagram and speed requirements, generally speaking, most of the 80 cylinder on the market is equipped with 3-4KW motor, 10-20 oil pump.

Can pneumatic cylinder be used as hydraulic cylinder?
The pneumatic cylinder can only be used for pressure below 1MPA, and if it is used for hydraulic, the pressure should be under 1MPA, which may not meet the strength requirements. And the seals should use fluorine rubber to avoid corrosion. But pneumatic cylinder used as hydraulic cylinder is not whimsical, in fact, there is such a use. The pneumatic system has a natural defect, that is, the speed is unstable, especially in the case of low speed. The hydraulic pressure is very stable, if you do not want to buy a set of hydraulic system, while the strength of the cylinder is not large, you can use compressed air to push the hydraulic oil, with hydraulic oil to drive the cylinder, The force is the same as compressed air, but very smooth.