pressure plate hydraulic cylinder Sold to Jordan

This article mainly introduces:

Jordan hydraulic cylinder,pressure plate hydraulic cylinder manufacturer,pressure plate hydraulic cylinder

(Jordan pressure plate hydraulic cylinder,produced by Hengyu Group）

pressure plate hydraulic cylinder are widely used in Jordan，because of no transmission clearance，powerful torque，clever hydraulic energy conversion.So our company has designed pressure plate hydraulic cylinder for customers from Jordan.

Introduction to pressure plate hydraulic cylinder:

The main role of the pressure plate hydraulic cylinder: the pressure plate hydraulic cylinder is an executive element in the hydraulic transmission system, which is an energy conversion device that converts hydraulic energy into mechanical energy. The hydraulic motor realizes continuous rotary motion, while the pressure plate hydraulic cylinder realizes reciprocating motion. The structure of the pressure plate hydraulic cylinder has three categories: piston pressure plate hydraulic cylinder, plunger pressure plate hydraulic cylinder, swing pressure plate hydraulic cylinder, piston pressure plate hydraulic cylinder and plunger pressure plate hydraulic cylinder to achieve reciprocating linear motion, output speed and thrust, swing pressure plate hydraulic cylinder to achieve reciprocating swing, output angular speed (speed) and torque. In addition to the single use of the pressure plate hydraulic cylinder, two or more can be combined or used in combination with other mechanisms. To fulfill a special function. The pressure plate hydraulic cylinder has simple structure and reliable operation, and has been widely used in the hydraulic system of machine tools.

The pressure of the sliding surface of the pressure plate hydraulic cylinder piston is too large, resulting in sintering. The piston tilts due to the weight of the piston rod, resulting in the phenomenon of non-stiffness, or the pressure of the sliding surface of the piston rises due to the action of the transverse load, which will cause sintering. In the design of the pressure plate hydraulic cylinder must study its working conditions, the length of the piston and bushing and the size of the clearance must be fully paid attention to.

1, the hydraulic machinery should be kept clean, in order to prevent dust and debris from falling into the oil, the tank should be sealed. 2, the oil in the tank should be replaced regularly according to the working condition. When changing the oil, the dirt and impurities accumulated at the bottom of the tank should be removed and the tank should be cleaned. 3, hydraulic oil, oil drums should be set in a clean and safe place to strengthen management. The oil drum, oil filter, oil funnel, oil pipe, etc. used should be kept clean. The oil drums for loading hydraulic oil must be cleaned in advance, and the oil drums should be dedicated and not mixed with other oil drums.

After the pressure plate hydraulic cylinder is installed, lubricating grease should be added to the relative moving parts such as earring and middle hinge shaft before trial operation.

Answers to some questions about pressure plate hydraulic cylinder:

Why is there noise in the hydraulic cylinder of the excavator lift arm?
There is no noise of a normal cylinder, check whether the throttle is ringing, or the mechanical part connected with it is ringing, and the mechanical part can be greased. If it can't be ruled out, disconnect the cylinder from the mechanical part and act alone to see what the situation is.

What is the difference between single acting hydraulic cylinder and double acting hydraulic cylinder?
Single action hydraulic cylinder is a single direction force work, the return of the plunger depends on itself or the weight of the mechanism to return. The double acting hydraulic cylinder is mainly different from the extension and retraction of the piston (the thrust and tension of the saying), which are all operated by the action of liquid pressure.