track steering cylinder Sold to Kazakhstan

This article mainly introduces:

Kazakhstan hydraulic cylinder,track steering cylinder manufacturer,track steering cylinder

(Kazakhstan track steering cylinder,produced by Hengyu Hydraulic Co., Ltd）

track steering cylinder are widely used in Kazakhstan，because of no transmission clearance，excellent temperature resistance，powerful torque.So our company has designed track steering cylinder for customers from Kazakhstan.

Introduction to track steering cylinder:

When the track steering cylinder is repaired, its inner and outer diameter and roundness should be accurately measured. If the inner hole of the track steering cylinder is badly worn, it can be repaired by grinding the mandrel or honing on the boring machine. If the piston is worn, it can be repaired by electroplating, and serious wear should be replaced.

When the track steering cylinder is in use, measures should be added to prevent the intrusion of pollutants. Effective measures should be taken to control the intrusion of pollutants, such as installing high-efficiency air filters in the tank breathing holes, new oil must be filtered, etc., but also must improve the anti-pollution ability of the track steering cylinder itself. In the seriously polluted environment, it is more important to pay attention to, such as the underground oil track steering cylinder should use fluorine rubber (FRM) and nitrile rubber (NBR) dust ring, and the ground mechanical track steering cylinder should use nitrile rubber dust ring; The filter device is added to the oil inlet of the track steering cylinder of the dump truck, construction machinery, work platform and other equipment, and in order to reduce the oil inlet resistance, the flow area should be increased as much as possible, which can effectively reduce the particle pollution from the system.

The track steering cylinder can not be used as grounding electrode to avoid electric damage to the piston rod.

When the initial action of the track steering cylinder is slow, please check the temperature of the hydraulic system, because in the case of low temperature, the viscosity of the hydraulic oil is large and the fluidity is poor, resulting in slow action of the track steering cylinder. The improvement method is to replace the hydraulic oil with good viscosity temperature performance, and the oil temperature at low temperature can be increased by heater or heating by the machine itself, and the normal working oil temperature of the system should be maintained at about 40 ° C.

Answers to some questions about track steering cylinder:

What is the difference between hydraulic piston cylinder and plunger cylinder?
The force surface of the piston cylinder is a rod cavity and a rodless cavity, and the force surface of the plunger cylinder is the plunger, the spring return single-acting piston cylinder can also rely on the external force of the spring to achieve return, the double-acting piston cylinder can produce tension, and the plunger cylinder only produces thrust without tension.

Two cylinders have a reversing control, if the load of the two cylinders is not the same, how to ensure their synchronization?
The piston rod of the cylinder is required to extend synchronization: install A shunt collector valve or synchronous motor at port A of the direction control valve, and then connect the two outlets of the shunt collector valve to the rod-free cavity of the two cylinders respectively. It is required that the outlet of the diverter collector valve is connected to the rod cavity of the two cylinders respectively when the piston rod is withdrawn in synchronization. The synchronization performance depends on the quality of the diverter valve and the leakage of the hydraulic system.