series synchronous cylinder Sold to Kenya

This article mainly introduces:

Kenya hydraulic cylinder,series synchronous cylinder manufacturer,series synchronous cylinder

(Kenya series synchronous cylinder,produced by Hengyu Group）

series synchronous cylinder are widely used in Kenya，because of long service life，excellent fatigue and impact resistance，no need for deceleration device.So our company has designed series synchronous cylinder for customers from Kenya.

Introduction to series synchronous cylinder:

Before the series synchronous cylinder is removed, the system should be unloaded, the loop pressure is zero, the oil source should be cut off, and the oil port should be blocked after the oil port distribution pipe is loosened.

When the series synchronous cylinder needs to be disassembled for maintenance due to leakage and other faults, the piston should be moved to the bottom position of the series synchronous cylinder, and hard beating and sudden drop are strictly prohibited during disassembly.

The repair method of the series synchronous cylinder: the repair of the series synchronous cylinder must use brush plating. This is because this repair method can be carried out on site, and the repair effect is good. In this way, loading and transportation can be eliminated to shorten the repair time and improve work efficiency. In addition, the coating obtained by brush plating has good binding force and will not have obvious boundaries. Moreover, the repair surface has high hardness and good wear resistance.

Most of the failure of the series synchronous cylinder is because there is a foreign body in the series synchronous cylinder into the failure of the series synchronous cylinder, the most problematic is that it is difficult to determine when the foreign body is into the series synchronous cylinder. After a foreign body enters, if the outer side of the sliding surface of the piston is equipped with a seal with a lip edge, then the lip edge of the seal can scrape the foreign body when working, which is beneficial to avoid scratching. However, the piston equipped with 0-shaped sealing ring has a sliding surface at both ends, and foreign bodies are sandwiched between this sliding surface, which is easy to form scars.

Answers to some questions about series synchronous cylinder:

How to disassemble injection molding machine injection cylinder?
If it is not repaired for a long time, it is recommended to open both ends, comprehensively check the oil seal and piston ring inside, this is not much difficulty, pay attention to not install reverse when changing the oil seal, some piston rings are steel rings are rubber rings, and several interfaces of steel rings are not in the same position; Rubber ring pay attention not to install reverse; Be careful not to damage the oil seal when installing, otherwise it will soon leak oil.

How to distinguish the size of hydraulic cylinder cavity?
The hydraulic cylinder has a rod cavity and a rodless cavity. The rod cavity is the cavity that the piston rod extends out. The rod cavity is of course small due to the existence of the piston rod. That's just relative.