bending machine hydraulic cylinder Sold to Croatia

This article mainly introduces:

Croatia hydraulic cylinder,bending machine hydraulic cylinder manufacturer,bending machine hydraulic cylinder

(Croatia bending machine hydraulic cylinder,produced by Hengyu Hydraulic Cylinder Factory）

bending machine hydraulic cylinder are widely used in Croatia，because of smooth movement，excellent temperature resistance，powerful torque.So our company has designed bending machine hydraulic cylinder for customers from Croatia.

Introduction to bending machine hydraulic cylinder:

The oil bending machine hydraulic cylinder is a part of the hydraulic system, in the hydraulic system, to reasonably design the heat dissipation system, to prevent the oil temperature is too high is the key to keep the hydraulic oil temperature normal. The temperature of the system should be kept in a suitable range to reduce the energy released when the bubble bursts. While not affecting the normal circulation of the coolant, a certain amount of anti-corrosion additives can be appropriately added to inhibit rust. When operating the hydraulic system, we should strive to be stable, not too fast, too strong, and try to reduce the impact of hydraulic oil on hydraulic components.

When the bending machine hydraulic cylinder is installed on the main engine, the oil port piping part and the guide sleeve should be checked for oil leakage in the running test, and the earring and the middle hinge shaft bearing should be refueled.

The bending machine hydraulic cylinder is not the same as the bending machine hydraulic cylinder, because the pressure of the pneumatic system is generally within the range of 0.2-1.0Mpa, the bending machine hydraulic cylinder can not be used as a high-power power component, but the bending machine hydraulic cylinder can be used as a relatively large power component, or the bending machine hydraulic cylinder system can be used.

The body of the bending machine hydraulic cylinder on the processing process requirements: the body of the bending machine hydraulic cylinder is an important and essential part of the bending machine hydraulic cylinder, because it has an irreplaceable role. The processing requirements for this part are very high, requiring that the surface roughness of the bending machine hydraulic cylinder after processing should reach 0.4-0.8um, and the coaxiality and wear resistance requirements are also very high.

Answers to some questions about bending machine hydraulic cylinder:

In hydraulic equipment, is the motor power related to the cylinder pressure holding time?
Irrelevant. The motor only drives the plunger in the hydraulic cylinder of the oil pump to extend out, and stops when the set pressure is reached; The length of the pressure holding time is related to the sealing degree of the hydraulic cylinder and the solenoid valve.

Why does the cylinder pop out of itself when it stops?
This situation has two possibilities, 1. There is more air in the system, so exhaust the gas. 2. The back pressure of the oil return is relatively large, check the oil return filter, check whether the cylinder has a rod cavity buffer is too tight, and choose a 3-position 4-way M-type valve for the reversing valve. In addition, after the shutdown, manually change the reversing valve back and forth several times, it should not rise out.