sanitation truck hydraulic cylinder Sold to Argentina

This article mainly introduces:

Argentina hydraulic cylinder,sanitation truck hydraulic cylinder manufacturer,sanitation truck hydraulic cylinder

(Argentina sanitation truck hydraulic cylinder,produced by Hengyu Hydraulic Co., Ltd）

sanitation truck hydraulic cylinder are widely used in Argentina，because of high work efficiency，excellent fatigue and impact resistance，no need for deceleration device.So our company has designed sanitation truck hydraulic cylinder for customers from Argentina.

Introduction to sanitation truck hydraulic cylinder:

Improve the service life of the sanitation truck hydraulic cylinder: it is necessary to maintain the normal clearance of the combined surface of the hydraulic components. When manufacturing or repairing the main parts of the sanitation truck hydraulic cylinder (such as the sanitation truck hydraulic cylinder block, piston rod, etc.), the assembly should be carried out in accordance with the tolerance lower limit of the assembly size, which can well reduce the occurrence of cavitation. If cavitation has occurred in the hydraulic components, only metallographic sandpaper polishing technology can be used to remove cavitation pitting and surface carbon deposits, and general fine sandpaper must not be used for polishing After the sanitation truck hydraulic cylinder is repaired, the hydraulic system should run smoothly for a certain period of time so that the hydraulic oil in the hydraulic system can be fully circulated; If necessary, the sanitation truck hydraulic cylinder inlet pipe (or return pipe) can be disassembled. Make the hydraulic oil overflow to achieve the effect of single sanitation truck hydraulic cylinder exhaust.

After the sanitation truck hydraulic cylinder is installed, lubricating grease should be added to the relative moving parts such as earring and middle hinge shaft before trial operation.

In the hydraulic system, sometimes the inner layer of the rubber hose is peeled off, so that the oil circuit is on and off, resulting in irregular sanitation truck hydraulic cylinder action. Troubleshooting method: Replace the rubber hose.

The sanitation truck hydraulic cylinder is mainly composed of body, piston, piston rod, sanitation truck hydraulic cylinder head, sanitation truck hydraulic cylinder bottom, piston rod head and related auxiliary devices. The piston divides the sanitation truck hydraulic cylinder into two chambers, and moves reciprocally in the sanitation truck hydraulic cylinder with the help of pressure oil. In order to improve its working effect, there is no sealing ring on the piston to eliminate internal leakage, where the piston rod passes through the sanitation truck hydraulic cylinder head, due to the existence of the gap, it is easy to produce external leakage phenomenon, and the dust can enter the sanitation truck hydraulic cylinder through the gap, so the sealing device and dust prevention reason are set. At the same time, in order to eliminate the influence of eccentric load on the work of the piston, all the sanitation truck hydraulic cylinders must be provided with a considerable length of guide sleeve at the extended end of the piston rod. In addition, in the case of faster piston movement, the phenomenon of mechanical collision between the piston and the sanitation truck hydraulic cylinder bottom and the sanitation truck hydraulic cylinder head is serious, so the buffer deceleration should be set at both ends of the sanitation truck hydraulic cylinder The working medium of the sanitation truck hydraulic cylinder: because it works at room temperature, the ordinary oil-type hydraulic oil can be selected; sanitation truck hydraulic cylinder sealing device: The use of Yx sealing ring, polyurethane (PU) and polytetrafluoroethylene (PTFE) materials combined to achieve a good sealing effect; Buffer mechanism of the sanitation truck hydraulic cylinder: The buffer structure of the sanitation truck hydraulic cylinder is to prevent the piston from colliding with the sanitation truck hydraulic cylinder head at the end of the stroke.

Answers to some questions about sanitation truck hydraulic cylinder:

How many boom cylinders, bucket rod cylinders and bucket cylinders are there in a small single-bucket excavator?
one for bucket, one for forearm, only one piece for a small excavator under the big arm, two pieces for medium and large excavator.

What are the main dimensions of the cylinder?
The main dimensions of the cylinder include: cylinder inner diameter, piston cylinder diameter, cylinder length, cylinder wall thickness, stroke, installation distance, etc.