steering power cylinder Sold to Uganda

This article mainly introduces:

Uganda hydraulic cylinder,steering power cylinder manufacturer,steering power cylinder

(Uganda steering power cylinder,produced by Hengyu Group）

steering power cylinder are widely used in Uganda，because of clever hydraulic energy conversion，simple structure and reliable operation，powerful torque.So our company has designed steering power cylinder for customers from Uganda.

Introduction to steering power cylinder:

When the steering power cylinder is installed on the main engine, the oil port piping part and the guide sleeve should be checked for oil leakage in the running test, and the earring and the middle hinge shaft bearing should be refueled.

If the seal of the steering power cylinder is softened and sticky, it may be that the seal is incompatible with the hydraulic oil or the nearby lubricating oil, replace the appropriate seal; If the seal becomes hard and loses elasticity, most of it is because the ambient temperature is too high (more than 80 ° C), make appropriate temperature insulation protection or replace the high temperature seal.

The definition of the minimum starting pressure of the steering power cylinder refers to the minimum working pressure of the steering power cylinder in the no-load state, which is a comprehensive index reflecting the manufacturing and assembly accuracy of the steering power cylinder parts and the size of the sealing friction.

In order to ensure the service life of the steering power cylinder, the medium used must not be mixed with impurities and stolen goods, so as to avoid scratching the inner arm of the steering power cylinder, causing damage to the seal and causing leakage in the steering power cylinder. It is required that the filtration accuracy of the system is not less than 80μm, the oil pollution is strictly controlled, the hydraulic oil is kept clean, the performance of the hydraulic oil is regularly checked, and the necessary fine filtration or replacement of the new working hydraulic oil is carried out.

Answers to some questions about steering power cylinder:

Is it normal for the cylinder to turn black?
Cylinder blackening is a soft fault: 1. It does not affect the normal operation of your equipment. 2. Cylinder blackening involves a lot of things: hydraulic oil, oil seal material, piston rod coating, etc. These three things are not determined by the manufacturer because these three things are provided by other manufacturers. If the equipment is not due to high temperature caused by the black cylinder, you do not have to worry too much because your excavator can still work normally. If you feel uncomfortable, you can choose to replace the cylinder or replace the hydraulic oil.

How to calculate the tonnage of hydraulic cylinder? The tonnage of the cylinder refers to the output force of the cylinder under rated working pressure: 1, for single rod piston hydraulic cylinder, it can be calculated by the area of the circle corresponding to the inner diameter of the cylinder A (square centimeter), and the rated working pressure of the system p (mpa), the value is equal to 10pA kg force, and the ton is 0.01pA. 2, for the double rod piston hydraulic cylinder, with A(square centimeter) to indicate the cylinder cylinder diameter and piston rod outer diameter defined by the ring area, with p (mpa) to indicate the rated working pressure of the system, the output force of the cylinder is 0.01pA ton force.