synchronous hydraulic cylinder Sold to America

This article mainly introduces:

America hydraulic cylinder,synchronous hydraulic cylinder manufacturer,synchronous hydraulic cylinder

(America synchronous hydraulic cylinder,produced by Hengyu Hydraulic Cylinder Factory）

synchronous hydraulic cylinder are widely used in America，because of high work efficiency，no need for deceleration device，excellent fatigue and impact resistance.So our company has designed synchronous hydraulic cylinder for customers from America.

Introduction to synchronous hydraulic cylinder:

Protection of the synchronous hydraulic cylinder surface: During the dismantling process, safety protection should be carried out on the synchronous hydraulic cylinder to prevent objects from falling and welding slag from falling to the surface, causing damage to the synchronous hydraulic cylinder surface. In the process of propulsion, the damaged pipe segments should be prevented from falling and smashing, and the slurry remaining on the surface of the synchronous hydraulic cylinder should be cleaned up in time.

After chrome plating of the piston rod of the synchronous hydraulic cylinder, the surface flatness is not fully treated: After chrome plating of the piston rod surface, the method of post-plating polishing should be changed to post-plating polishing. Although it is necessary to increase the thickness of the coating before grinding (generally increased by about 0.02 in the diameter direction), it can remove chrome plating defects well, and test the binding force of the coating. In addition, due to the micro-roughness of the grinding surface, the trough can store lubricating oil, which can improve the wear resistance and extend the service life.

How to repair the synchronous hydraulic cylinder body when it is damaged: When the synchronous hydraulic cylinder has trace deformation and shallow tensile marks, the synchronous hydraulic cylinder is repaired by strong honing process. The heavy honing process can repair synchronous hydraulic cylinders up to 2.5 times out of tolerance than the original tolerance. It honed the parts with excessive size or shape error through a powerful honing machine, so that the overall size, shape tolerance and roughness of the synchronous hydraulic cylinder can meet the technical requirements.

The wear of the hard chromium plating layer of the synchronous hydraulic cylinder is mostly caused by the grinding of the friction iron powder of the piston, and the wear is faster when there is water in the middle. Corrosion caused by the contact potential difference of the metal only occurs in the part of the piston contact, and the corrosion occurs in a point pattern. As mentioned above, when there is moisture in the middle, it will promote the development of corrosion. Compared with castings, the contact potential difference of copper alloy is higher, so the corrosion degree of copper alloy is more serious.

Answers to some questions about synchronous hydraulic cylinder:

The two cylinders of the bending machine are out of sync?
Check whether the sliding slide is worn, adjust its tightness, so that both sides are consistent, check whether the two cylinder tubing is connected, tighten the flow valve, pressure, let the cylinder air discharge.

What's a minus 40 cylinder made of?
Construction with 1Cr18Ni9Ti, in low temperature conditions impact and tensile strength are very good, can withstand -100 degrees of low temperature, corrosion resistance, material price is not very high, more economic.