double discharge cylinder Sold to Japan

This article mainly introduces:

Japan hydraulic cylinder,double discharge cylinder manufacturer,double discharge cylinder

(Japan double discharge cylinder,produced by Hengyu Group）

double discharge cylinder are widely used in Japan，because of clever hydraulic energy conversion，simple structure and reliable operation，excellent temperature resistance.So our company has designed double discharge cylinder for customers from Japan.

Introduction to double discharge cylinder:

In the hydraulic system, sometimes the inner layer of the rubber hose is peeled off, so that the oil circuit is on and off, resulting in irregular double discharge cylinder action. Troubleshooting method: Replace the rubber hose.

When the double discharge cylinder is in use, measures should be added to prevent the intrusion of pollutants. Effective measures should be taken to control the intrusion of pollutants, such as installing high-efficiency air filters in the tank breathing holes, new oil must be filtered, etc., but also must improve the anti-pollution ability of the double discharge cylinder itself. In the seriously polluted environment, it is more important to pay attention to, such as the underground oil double discharge cylinder should use fluorine rubber (FRM) and nitrile rubber (NBR) dust ring, and the ground mechanical double discharge cylinder should use nitrile rubber dust ring; The filter device is added to the oil inlet of the double discharge cylinder of the dump truck, construction machinery, work platform and other equipment, and in order to reduce the oil inlet resistance, the flow area should be increased as much as possible, which can effectively reduce the particle pollution from the system.

If the seal of the double discharge cylinder is abnormal wear, you can check whether the speed control valve is improperly adjusted, resulting in too high back pressure and improper installation of the seal or hydraulic oil contamination. The second is whether there is a foreign body entering the assembly and the quality of the sealing material is not good. The result is that the action is slow and weak, and in serious cases, it will cause damage to the piston and double discharge cylinder, and the phenomenon of "pulling the double discharge cylinder" appears. The treatment method is to adjust the speed control valve, and the necessary operation and improvement should be done according to the installation instructions.

double discharge cylinder buffer valve inspection and maintenance: For the valve buffer double discharge cylinder, the focus should be on checking the wear of the buffer valve spool and seat. Once it is found that the amount of wear increases and the seal fails, it should be replaced. It can also be repaired by using abrasive spool and seat matching grinding method.

Answers to some questions about double discharge cylinder:

What is the function of the forklift truck cylinder and how does it work?
(1) In order to quickly and conveniently pick up the goods, the gantry needs to be tilted forward; In order to prevent the goods from falling, the door frame should be tilted backward to ensure the stability of the goods. The front and back tilt of the frame is accomplished by tilting the oil cylinder. (2) The inclined cylinder is composed of a piston, a cylinder block, a piston rod, an upper cover, a lower cover, a compression nut and a cover female and other main parts. (3) The inclined cylinder has two oil holes that can be interchanged into oil inlet and discharge holes. The cylinder is divided into a front cavity and a back cavity by a piston. The back cavity is filled with high-pressure oil when it tilts forward, and the front cavity is filled with high-pressure oil when it tilts backward.

What is the material of the lift cylinder?
The cylinder is composed of many parts. The cylinder also contains the seal and the installation port at both ends, the material of these two parts is not easy to determine if there is no physical object. The cylinder body is generally 20 steel, 45 steel, 27SiMn and other materials, and the piston rod is generally 40Cr, 45 steel and other materials.