hydraulic jig cylinder Sold to Greece

This article mainly introduces:

Greece hydraulic cylinder,hydraulic jig cylinder manufacturer,hydraulic jig cylinder

(Greece hydraulic jig cylinder,produced by Hengyu Hydraulic Co., Ltd）

hydraulic jig cylinder are widely used in Greece，because of excellent fatigue and impact resistance，no need for deceleration device，long service life.So our company has designed hydraulic jig cylinder for customers from Greece.

Introduction to hydraulic jig cylinder:

hydraulic jig cylinder can not drive the load troubleshooting: oil pressure is too low. hydraulic jig cylinder selection specifications are too small. Leakage in hydraulic jig cylinder or associated hydraulic system element.

How the cavitation of the hydraulic jig cylinder is formed: With the gradual rise of pressure, the gas in the oil will become bubbles, when the pressure rises to a certain limit value, these bubbles will break under the action of high pressure, so that the high temperature and high pressure gas will quickly act on the surface of the parts, resulting in cavitation of the hydraulic jig cylinder, resulting in corrosive damage to the parts.

hydraulic jig cylinder body inspection: The inner surface of the hydraulic jig cylinder and the piston seal are the main factors causing the leakage in the hydraulic jig cylinder, if the hydraulic jig cylinder has a longitudinal tensile mark, even if the new piston seal is replaced, it can not effectively eliminate the fault, the inner surface of the hydraulic jig cylinder mainly checks whether the dimensional tolerance and shape and position tolerance meet the technical requirements, there is no longitudinal tensile mark, and measures the depth of the longitudinal tensile mark, in order to take the corresponding solution.

In the case of serious wear on the inner surface of the hydraulic jig cylinder, or when there is a deep longitudinal tensile mark, it should be mapped according to the physical object and re-produced by the professional manufacturer according to the hydraulic jig cylinder manufacturing process for replacement. The hydraulic jig cylinder can also be repaired with TS311 antiwear repair agent. TS311 anti-wear repair agent is mainly used for the repair of worn and slipped metal parts.

Answers to some questions about hydraulic jig cylinder:

Is there a way to make the cylinder stop pushing when it hits something hard during the process of pushing?
The simplest solution is to press the stop switch, this switch has a mechanical type, touch the object on the action or send a stop signal, through the operation of the motor control cylinder; There is also an induction switch, that is, when the hydraulic cylinder expands to the range of the induction switch can sense the signal, it sends a signal to let the motor act, resulting in the corresponding action of the cylinder.

How to distinguish the bucket cylinder from the bucket rod cylinder?
It can be distinguished according to its installation and connection: one end of the bucket cylinder is connected with the bucket; The rod cylinder is not connected to the bucket. The bucket refers to the bucket installed on the excavator. According to the working mode, it is divided into backhoe bucket and shovel bucket, the backhoe bucket is commonly used. The boom and bucket rod are working device of the excavator, usually called the big arm and the forearm, which are mainly used to control the digging and loading of the bucket. The arm connected to the frame is longer, so it is commonly known as the big arm, and its term is called the boom. The arms connected to the digging bucket are smaller, so they are commonly known as the lower arms, and the term is called the bucket rod, so they are commonly known as the big lower arms.