cylinder of the plate rolling machine Sold to Indonesia

This article mainly introduces:

Indonesia hydraulic cylinder,cylinder of the plate rolling machine manufacturer,cylinder of the plate rolling machine

(Indonesia cylinder of the plate rolling machine,produced by Hengyu Group）

cylinder of the plate rolling machine are widely used in Indonesia，because of no transmission clearance，no transmission clearance，long service life.So our company has designed cylinder of the plate rolling machine for customers from Indonesia.

Introduction to cylinder of the plate rolling machine:

When the cylinder of the plate rolling machine is in use, once the seal and guide support ring are found to be defective, the seal with the same structural form and appropriate material should be replaced according to the structural form of the cylinder of the plate rolling machine seal to be repaired, so as to minimize the thickness of the oil film between the seal and the sealing surface and reduce the leakage of the seal.

If the cylinder of the plate rolling machine piston rod is found to be worn, it can be brushed and plated first, then ground, and finally adjust the mating accuracy of the piston rod and the guide sleeve. At this time, the guide sleeve can be properly redrilled or the guide sleeve can be re-turned. When making the above repairs, remember to replace various rubber seals in time.

The daily inspection of the cylinder of the plate rolling machine includes: checking the connection of the cylinder of the plate rolling machine and the pipe joint for leaks. Check the cylinder of the plate rolling machine rod for leaks. Check the cylinder of the plate rolling machine connection for leaks. When the cylinder of the plate rolling machine moves, the work is normal and smooth. Whether the cylinder of the plate rolling machine has internal leakage.

When installing the cylinder of the plate rolling machine, the axial ends of the cylinder of the plate rolling machine cannot be fixed. Due to the effect of liquid pressure and thermal expansion in the cylinder of the plate rolling machine, there is axial expansion. If the two ends of the cylinder of the plate rolling machine are fixed, all parts of the cylinder of the plate rolling machine will be deformed. When disassembling the cylinder of the plate rolling machine, it is strictly forbidden to hammer the cylinder of the plate rolling machine and the piston surface, such as the cylinder of the plate rolling machine hole and the piston surface is damaged, do not allow sandpaper grinding, to use a fine oil stone carefully grinding. The clearance between the guide sleeve and the piston rod should meet the requirements.

Answers to some questions about cylinder of the plate rolling machine:

What causes hydraulic cylinder oil leakage?
1. Internal leakage (1) The wear ring on the piston is seriously worn, leading to friction between the piston and the cylinder liner, and finally strain the cylinder liner, piston and seal; 2) Seal long-term use failure, piston seal (mostly U, V, Y ring, etc.) aging; 3) The hydraulic oil is dirty, and a large number of impurities enter the cylinder and wear the piston seal to bad; 2. External leakage 1) cylinder inlet and outlet tubing joint cracking; (This I see in the actual work is still more) 2) The piston rod extension end with the piston rod seal damage, mostly due to the piston cylinder is caused by hair, but also caused by aging; 3) The seal between the extended end of the piston rod and the liner is damaged.

What are the main dimensions of the cylinder?
The main dimensions of the cylinder include: cylinder inner diameter, piston cylinder diameter, cylinder length, cylinder wall thickness, stroke, installation distance, etc.