shearing machine cylinder Sold to Ethiopia

This article mainly introduces:

Ethiopia hydraulic cylinder,shearing machine cylinder manufacturer,shearing machine cylinder

(Ethiopia shearing machine cylinder,produced by Hebei Hengyu company）

shearing machine cylinder are widely used in Ethiopia，because of clever hydraulic energy conversion，simple structure and reliable operation，powerful torque.So our company has designed shearing machine cylinder for customers from Ethiopia.

Introduction to shearing machine cylinder:

Regular maintenance of the shearing machine cylinder includes: regular tightening, shearing machine cylinder fastening screws and gland screws, shearing machine cylinder piston rod stop adjustment screws, should be tightened once a month, tighten each screw evenly, and achieve the corresponding tightening torque. Replace the seal regularly, it is recommended to replace the seal of the shearing machine cylinder once a year. Clean regularly, the shearing machine cylinder is cleaned every other year, and the seals are replaced while cleaning.

If the seal of the shearing machine cylinder is softened and sticky, it may be that the seal is incompatible with the hydraulic oil or the nearby lubricating oil, replace the appropriate seal; If the seal becomes hard and loses elasticity, most of it is because the ambient temperature is too high (more than 80 ° C), make appropriate temperature insulation protection or replace the high temperature seal.

shearing machine cylinder to reasonable use of hydraulic oil: strict hydraulic oil selection off. Hydraulic oil is selected in strict accordance with oil standards. The selection of good quality hydraulic oil can effectively prevent bubbles in the working process of the hydraulic system. When choosing the oil, it should be selected according to the lowest temperature in different regions, and fill the hydraulic oil according to the dipstick standard, and at the same time, it should also keep the hydraulic system clean (when filling the hydraulic oil, it should prevent the water and other impurities into it), and often check the oil quality, oil level and oil color of the hydraulic oil. If blisters and bubbles are found in the hydraulic oil. When the oil becomes milky white, the source of the air in the oil should be carefully found and eliminated in time.

In the hydraulic system, sometimes the inner layer of the rubber hose is peeled off, so that the oil circuit is on and off, resulting in irregular shearing machine cylinder action. Troubleshooting method: Replace the rubber hose.

Answers to some questions about shearing machine cylinder:

Why should the piston rod of the hydraulic cylinder be so precise? If you hope the cylinder has a long service cycle, then all parts need to be high-precision, not only the piston rod, but also the cylinder, the sealing groove, the surface roughness, the cylinder looks very simple. Any hydraulic factory can produce the cylinder, but the good cylinder is difficult to produce.

The cylinder is moving too fast. I want to slow it down. What can I do?
The hydraulic cylinder is the execution action, and the power source is the hydraulic system. The cylinder speed is too fast, indicating that the system flow is large, the hydraulic system has a hydraulic valve responsible for speed control function, method: 1, by adjusting the speed control valve to reduce the speed; 2, the speed control valve has been adjusted to the lowest, indicating that the hydraulic system design flow is too high, the need to re-configure the hydraulic system according to demand, or the cylinder diameter is changed.