stroke adjustable cylinder Sold to Ghana

This article mainly introduces:

Ghana hydraulic cylinder,stroke adjustable cylinder manufacturer,stroke adjustable cylinder

(Ghana stroke adjustable cylinder,produced by Hengyu Group）

stroke adjustable cylinder are widely used in Ghana，because of no transmission clearance，powerful torque，clever hydraulic energy conversion.So our company has designed stroke adjustable cylinder for customers from Ghana.

Introduction to stroke adjustable cylinder:

When the stroke adjustable cylinder is in use, measures should be added to prevent the intrusion of pollutants. Effective measures should be taken to control the intrusion of pollutants, such as installing high-efficiency air filters in the tank breathing holes, new oil must be filtered, etc., but also must improve the anti-pollution ability of the stroke adjustable cylinder itself. In the seriously polluted environment, it is more important to pay attention to, such as the underground oil stroke adjustable cylinder should use fluorine rubber (FRM) and nitrile rubber (NBR) dust ring, and the ground mechanical stroke adjustable cylinder should use nitrile rubber dust ring; The filter device is added to the oil inlet of the stroke adjustable cylinder of the dump truck, construction machinery, work platform and other equipment, and in order to reduce the oil inlet resistance, the flow area should be increased as much as possible, which can effectively reduce the particle pollution from the system.

When the stroke adjustable cylinder wear is serious, you can try to use an alloy scraper to shave grooves with a depth of more than 1mm on the surface of the slip injury, then clean the grooves with acetone, apply the adjusted TS311 anti-wear repair agent on the polished surface with the stroke adjustable cylinder inner diameter copying plate, and scrape it flat vigorously to ensure compaction and higher than the inner surface of the stroke adjustable cylinder. After curing, polish to leave a finishing margin. Finally, the overall size, shape tolerance and roughness of the stroke adjustable cylinder can meet the requirements by grinding. However, the life and reliability of this repair stroke adjustable cylinder are not high.

The machining accuracy of the stroke adjustable cylinder depends on the level of equipment, production technology and testing means. stroke adjustable cylinder processing methods are commonly used in two ways, one is rough boring - fine boring - rolling, generally with 45# seamless steel pipe, this method of processing quality is good, but the cost is high. Another method is to use 20# cold-drawn seamless steel pipe, and then honing, the cost is lower. The piston rod must be adjusted and straightened before processing, and the coating thickness of the piston rod is generally not less than 0.03mm. The piston must be machined in strict accordance with the groove size and tolerance requirements given in the seal manual.

Because of the slightly complex structure of the buffer stroke adjustable cylinder, sometimes there will be problems, such as when the stroke adjustable cylinder with the buffer device is started in reverse, the piston often stops temporarily or reverses. Elimination method: The orifice of the check valve is too small, so that the amount of oil entering the buffer chamber is too small, and even a vacuum occurs, so the above fault phenomenon will occur when the buffer plunger leaves the end cover. In this regard, the orifice of the check valve should be increased.

Answers to some questions about stroke adjustable cylinder:

Slide weight 35 kg exit stroke 55mm, is it suitable to use 40 cylinder diameter cylinder?
The maximum output force of the 40-bore hydraulic cylinder can reach 2 tons, and whether it can be used depends on the use scenario. In addition, the problem of mechanism stuck has nothing to do with the size of the power source, and reasonable structural design and good machining and assembly accuracy are the key.

What is the smallest cylinder size?
The smallest shape cylinder I have ever seen is a hydraulic clamping cylinder in the machine tool industry. Outer diameter 24 mm, total length 23 mm, travel 4 mm. Weighs 0.05 kg. Maximum clamping force 3500 Newtons.