tailboard balance cylinder Sold to India

This article mainly introduces:

India hydraulic cylinder,tailboard balance cylinder manufacturer,tailboard balance cylinder

(India tailboard balance cylinder,produced by Hengyu Hydraulic Co., Ltd）

tailboard balance cylinder are widely used in India，because of high work efficiency，excellent fatigue and impact resistance，no need for deceleration device.So our company has designed tailboard balance cylinder for customers from India.

Introduction to tailboard balance cylinder:

In the case of serious wear on the inner surface of the tailboard balance cylinder, or when there is a deep longitudinal tensile mark, it should be mapped according to the physical object and re-produced by the professional manufacturer according to the tailboard balance cylinder manufacturing process for replacement. The tailboard balance cylinder can also be repaired with TS311 antiwear repair agent. TS311 anti-wear repair agent is mainly used for the repair of worn and slipped metal parts.

Regular maintenance of the tailboard balance cylinder includes: regular tightening, tailboard balance cylinder fastening screws and gland screws, tailboard balance cylinder piston rod stop adjustment screws, should be tightened once a month, tighten each screw evenly, and achieve the corresponding tightening torque. Replace the seal regularly, it is recommended to replace the seal of the tailboard balance cylinder once a year. Clean regularly, the tailboard balance cylinder is cleaned every other year, and the seals are replaced while cleaning.

When installing the tailboard balance cylinder, the axial ends of the tailboard balance cylinder cannot be fixed. Due to the effect of liquid pressure and thermal expansion in the tailboard balance cylinder, there is axial expansion. If the two ends of the tailboard balance cylinder are fixed, all parts of the tailboard balance cylinder will be deformed. When disassembling the tailboard balance cylinder, it is strictly forbidden to hammer the tailboard balance cylinder and the piston surface, such as the tailboard balance cylinder hole and the piston surface is damaged, do not allow sandpaper grinding, to use a fine oil stone carefully grinding. The clearance between the guide sleeve and the piston rod should meet the requirements.

Piston tailboard balance cylinder is widely used in hydraulic transmission. When the tailboard balance cylinder works, it mainly delivers hydraulic oil alternately to both sides of the piston in the tailboard balance cylinder, and uses the pressure difference of hydraulic oil on both sides of the piston to realize the reciprocating movement of the piston. If you want to speed up the forward speed of the piston, the return oil in the tailboard balance cylinder can be controlled by the valve and directly input into the inlet pipe to participate in the work of the piston to achieve rapid movement of the piston, but the thrust of the piston is reduced much.

Answers to some questions about tailboard balance cylinder:

How to remove the air in hydraulic cylinder?
Connected the cylinder to the system, and reciprocating move with full stroke several times, then the air can be eliminated . There is also a clunky method as follows: first remove the rod cavity oil pipe, connect the rodless cavity oil circuit to extend all the cylinders, and then remove the rodless cavity oil pipe, connect the rod cavity oil pipe and withdraw all the cylinders, and then connect the rodless cavity oil pipe, so that there is no air in the cylinder.

How to refuel pneumatic riveting cylinder?
First put the gun flat, that is, horizontally, while pushing the stroke positioning pin and loosen the back cover, rotate to the left for a maximum of five turns, and then use a wrench to loosen the oil sealing screw, slowly add the hydraulic oil and let the air out, fill up to tighten the oil sealing screw. This process of adding hydraulic oil is over.