servo cylinder Sold to Turkmenistan

This article mainly introduces:

Turkmenistan hydraulic cylinder,servo cylinder manufacturer,servo cylinder

(Turkmenistan servo cylinder,produced by Hengyu Hydraulic Cylinder Factory）

servo cylinder are widely used in Turkmenistan，because of excellent fatigue and impact resistance，no need for deceleration device，long service life.So our company has designed servo cylinder for customers from Turkmenistan.

Introduction to servo cylinder:

When the servo cylinder is installed on the main engine, the oil port piping part and the guide sleeve should be checked for oil leakage in the running test, and the earring and the middle hinge shaft bearing should be refueled.

Most of the failure of the servo cylinder is because there is a foreign body in the servo cylinder into the failure of the servo cylinder, the most problematic is that it is difficult to determine when the foreign body is into the servo cylinder. After a foreign body enters, if the outer side of the sliding surface of the piston is equipped with a seal with a lip edge, then the lip edge of the seal can scrape the foreign body when working, which is beneficial to avoid scratching. However, the piston equipped with 0-shaped sealing ring has a sliding surface at both ends, and foreign bodies are sandwiched between this sliding surface, which is easy to form scars.

The wear of the hard chromium plating layer of the servo cylinder is mostly caused by the grinding of the friction iron powder of the piston, and the wear is faster when there is water in the middle. Corrosion caused by the contact potential difference of the metal only occurs in the part of the piston contact, and the corrosion occurs in a point pattern. As mentioned above, when there is moisture in the middle, it will promote the development of corrosion. Compared with castings, the contact potential difference of copper alloy is higher, so the corrosion degree of copper alloy is more serious.

The servo cylinder should be vented: when the servo cylinder is installed or parked for a long time to work again, the air will penetrate into the servo cylinder and the pipeline system. In order to prevent the abnormal phenomenon of crawling, noise and heating of the actuator, the air in the servo cylinder and the system should be discharged. In order to facilitate the removal of air deposited in the servo cylinder, the oil is best entered and discharged from the highest point of the servo cylinder. servo cylinders that require higher motion stability are often equipped with exhaust plugs at both ends. Before working, unscrew the exhaust plug to make the piston go back and forth several times without load in the whole stroke, and the air can be discharged through the exhaust plug. After the air is drained, tighten the exhaust plug before working.

Answers to some questions about servo cylinder:

Does the sealing string of the upper and lower chamber of the hydraulic cylinder fall by itself?
It is possible, the probability accounts for 85% (depending on the weight), the weight is less than the system resistance, may not fall, the weight is greater than the system resistance, will not necessarily fall, so often check the equipment, safety first, find the problem in time to solve, the cylinder is not very expensive parts, maintenance does not cost much money, However, accidents caused by cylinder failure will lose several times the cost.

The pressure gauge of the hydraulic station reaches 20MPa. How many tons of weight can the hydraulic cylinder lift? How to convert?
20Mpa=200kg/cm^2 The weight of the cylinder with a cross-sectional area of 1 square centimeter can be lifted is 200kg, so F=200X3.14X (125/2) ^2 =24531kg =24.5 tons.