baling press cylinder Sold to Cameroon

This article mainly introduces:

Cameroon hydraulic cylinder,baling press cylinder manufacturer,baling press cylinder

(Cameroon baling press cylinder,produced by Hengyu Hydraulic Co., Ltd）

baling press cylinder are widely used in Cameroon，because of smooth movement，high work efficiency，excellent fatigue and impact resistance.So our company has designed baling press cylinder for customers from Cameroon.

Introduction to baling press cylinder:

If the seal of the baling press cylinder is softened and sticky, it may be that the seal is incompatible with the hydraulic oil or the nearby lubricating oil, replace the appropriate seal; If the seal becomes hard and loses elasticity, most of it is because the ambient temperature is too high (more than 80 ° C), make appropriate temperature insulation protection or replace the high temperature seal.

baling press cylinder can not drive the load troubleshooting: oil pressure is too low. baling press cylinder selection specifications are too small. Leakage in baling press cylinder or associated hydraulic system element.

When purchasing the baling press cylinder, try to clarify the following parameters of the baling press cylinder: A. baling press cylinder diameter, rod diameter, stroke; B. Working pressure or baling press cylinder load; C. Working environment temperature; D. Working medium; E. Operating speed; F. Other parameters, such as connection form, mounting size, etc. In this way, the right baling press cylinder type can be found accurately and quickly.

Before the baling press cylinder is removed, the system should be unloaded, the loop pressure is zero, the oil source should be cut off, and the oil port should be blocked after the oil port distribution pipe is loosened.

Answers to some questions about baling press cylinder:

Two cylinders in parallel, how to solve the synchronization problem?
The following methods can be used to achieve parallel cylinder synchronization: 1, rigid mechanical synchronization. 2. The throttle valve or speed regulating valve is used in the circuit to adjust the synchronization. 3, the two cylinders use independent quantitative pump oil supply to achieve synchronization. 4. Synchronous motor is used in the loop to realize cylinder synchronization. 5, using the position sensor to measure the stroke position and control the cylinder synchronization through the electrical system.

Is there a national standard for the testing of hydraulic cylinders?
Generally speaking, the cylinder test is carried out according to JB/JQ20302 Allowable leakage of cylinder in pre-factory leakage test. GB2879 hydraulic cylinder piston and piston rod dynamic seal groove type, size and tolerance. GB6578 hydraulic cylinder piston rod dust ring groove type, size and tolerance. GB7938 hydraulic cylinder and cylinder nominal pressure series, etc.