rolling mill cylinder Sold to UAE

This article mainly introduces:

UAE hydraulic cylinder,rolling mill cylinder manufacturer,rolling mill cylinder

(UAE rolling mill cylinder,produced by Hebei Hengyu company）

rolling mill cylinder are widely used in UAE，because of clever hydraulic energy conversion，simple structure and reliable operation，excellent temperature resistance.So our company has designed rolling mill cylinder for customers from UAE.

Introduction to rolling mill cylinder:

rolling mill cylinder use should try to avoid sealing belt into the rolling mill cylinder. As a simple sealing material, polytetrafluoroethylene plastic sealing tape is often used in installation and inspection, and if the winding method of the linear and ribbon-shaped sealing material is wrong, the sealing tape will be cut off and enter the rolling mill cylinder. The wire belt seal will not have any effect on the winding of the sliding part, but it will cause the check valve of the rolling mill cylinder to fail to operate or the buffer regulating valve can not be adjusted to the end. For the circuit, it may cause the action of the reversing valve, the relief valve and the reducing valve to fail.

Causes and countermeasures of oil rolling mill cylinder leakage: Cast iron ring seal allows a certain degree of internal leakage. The impurities in the rolling mill cylinder will lead to premature wear of the piston seal, replace the piston seal; If the rolling mill cylinder is visibly scarred, the rolling mill cylinder must be replaced. It can be pressurized at one end of the rolling mill cylinder and opened at the other end of the oil port to observe whether there is obvious internal leakage at the end of the oil port. Most rolling mill cylinder piston drift may not come from the rolling mill cylinder, the above method to determine the rolling mill cylinder without internal leakage is helpful to determine the problem of the hydraulic system related components.

Do not enter foreign bodies when installing the rolling mill cylinder block. The place where the installation operation is carried out, the conditions are not good, and foreign bodies can be entered unconsciously. Therefore, the installation site must be cleaned up around, especially the place where the parts are placed must be cleaned, so that there is no dirt.

The material, shape and compression of the rolling mill cylinder seal have a great impact on the service life and work efficiency of the rolling mill cylinder. In addition to requiring a reliable seal, it should also have a long service life and less friction loss. At present, there are many seal manufacturers in the country, and it is also crucial to choose high-quality seals with reliable and stable quality.

Answers to some questions about rolling mill cylinder:

The hydraulic cylinder is slow when moving forward and faster when moving back.
If the cylinder is single, it is slow when it is moving forward without the rod cavity, and fast when it is shrinking.

What is hydraulic cylinder？ How to use hydraulic cylinder？ what is the application of hydraulic cylinder?
Hydraulic cylinder is the hydraulic actuator that converts hydraulic energy into mechanical energy and does linear reciprocating movement (or swing movement). It is simple in structure and reliable in operation. When it is used to achieve reciprocating movement, the deceleration device can be eliminated, and there is no transmission gap, and the movement is smooth, so it is widely used in various mechanical hydraulic systems. The output force of the hydraulic cylinder is proportional to the effective area of the piston and the pressure difference between the two sides. The hydraulic cylinder is basically composed of cylinder body, cylinder head, piston, piston rod, sealing device, buffer device and exhaust device. Buffer device and exhaust device depending on the specific application, other devices are essential. Hydraulic cylinders are mainly used in machinery.